Network Menu - Hitachi CP-SX12000 User Manual

NETWORK menu

NETWORK menu
Remember that incorrect network settings on this
projector may cause trouble on the network. Be sure
to consult with your network administrator before
connecting to an existing access point on your
network.
Select "NETWORK" from the main menu to access
the following functions.
Select an item using the ▲/▼ cursor buttons on the projector or remote control,
and press the ► cursor button on the projector or remote control, or ENTER
button on the remote control to execute the item. Then perform it according to the
following table.
See the User's Manual - Network Guide for details of NETWORK operation.
NOTE
• If you are not utilizing SNTP (Date/Time Settings of the User's
Manual - Network Guide), then you must set the DATE AND TIME during the
initial installation.
Item
SETUP
(continued on next page)
56
Selecting this item displays the SETUP
Menu for the network.
Use the ▲/▼ buttons to select an item,
and the ► or ENTER button on the remote
control to perform the item.
Use the ▲/▼ buttons to turn DHCP on/off.
ON ó OFF
DHCP
Select OFF when the network does
(Dynamic
not have DHCP enabled.
Host
• When the "DHCP" setting changes to "ON", it takes a
Configuration
little time to obtain IP address from DHCP server.
Protocol)
• Auto IP function will be assigned an IP address if the
projector could not obtain an IP address from server
even if DHCP is "ON".
Description