Part Names; Projector - Hitachi CP-SX12000 User Manual

Part names

Projector

(1) Dust protector
(2) Remote sensors (x 2) (17)
(3) Exhaust vents
(4) Filter cover (69)
The filter unit and intake vent are
inside.
(5) Control panel (6)
(6) Rear panel (6)
(7) Shutdown switch (73)
(8) Lamp cover (67)
The lamp unit is inside.
(9) AC IN (AC inlet) (15)
(10) Power switch (19,20)
(11) Security bar (10)
(12) Security slot (10)
(13) Dented part (x 2) (3)
(14) Elevator feet (x 2) (20)
WARNING
vents during use or just after use, since it is hot.
►Do not look into the lens or vents while the lamp is on, since the strong light is
not good for your eyes.
►Do not grab the front cover or front ring to hold the projector, since you can
drop the projector.
►Do not handle the elevator feet without holding the projector, since the
projector may drop down.
CAUTION
heating up. Do not cover, block or plug up the vents. Do not place anything that
can stick or be sucked to the vents, around the intake vents. Clean the air filter
periodically.
NOTICE
►Do not touch the lens surface directly.
► Keep the dust protector of the projector, and use it when no lens unit is
attached to the projector.
►HOT! : Do not touch around the lamp cover or the exhaust
►Maintain normal ventilation to prevent the projector from
Front ring
(1)
See the NOTICE
(7)
(8)
HOT!
(9)
(10)
(11)
(12)
(14)
Part names
Front cover
(3)
(2)
(4)
(5)
(6)
(13)
HOT!
5