Victorian Plumbing Chatsworth Chatsworth Fitting Instructions Manual page 4

If you need to change the thermostatic cartridge, Please follow these steps:
1. Turn off the mains water supply,
make sure the flow handle is turned
off.
2. Take off the handle cap and
remove the screw (Fig. 1).
3. Remove the temperature location
ring (Fig.2), loosen the grub screw
with an allen key and take out the
cartridge (Fig.3).
4. Put the temperature location ring
on the new cartridge (Fig. 4), make
sure the temperature location
ring is on the same line with the
mark on the cartridge. Adjust the
cartridge screw hole to line up with
the valve screw hole (Fig. 5), then
place the cartridge inside the valve.
Tighten the cartridge with a grub
screw (Fig. 6).
Cartridge
5. Turn on mains water supply, check
the water flow and temperature
control.
Fig. 3
Cartridge
Cartridge
Fig. 5
Valve screw hole
Cartridge screw hole
Notice:
Make sure the cartridge is at the original state and isn't turned, if the cartridge has
been turned during assembling you can turn it back to its original state. Turn the mark
on the cartridge back to the same line.
Check the 38˚C mark on the handle and align the 38˚C with the line mark on the
Valve screw hole
Cartridge screw hole
cartridge. Assemble the handle with screw (Fig. 6).
V4.05.24
Cartridge screw hole
Changing Thermostatic Cartridge
Cartridge
Cartridge
Cartridge screw hole
Cartridge screw hole
Fig. 1
Fig. 2
Cartridge
Screw hole
Temperature
location ring
Fig. 4
Cartridge
Screw hole
Temperature
location ring
Cartridge
Screw hole
Fig. 6
Temperature
location ring
Valve screw hole
Temperature
locating ring
Temperature
locating ring
Temperature
locating ring
Cartridge
Screw hole
Temperature
location ring
Cartridge
Cartridge
Screw hole
Temperature
location ring
Cartridge screw hole
Temperatu
locating r
Temperat
locating