Machine Operations And Controls; Checks And Adjustment Before Starting Engine - Komatsu D61EXi-24 Operation & Maintenance Manual

MACHINE OPERATIONS AND CONTROLS

MACHINE OPERATIONS AND CONTROLS

CHECKS AND ADJUSTMENT BEFORE STARTING ENGINE

Before starting the automatic control of the blade, perform the same walk-around checks, checks before starting
(start-up inspection) and adjustment as of standard machine.
For the method of checks and adjustment, see the Operation and Maintenance Manual for standard machine.
1.
Set the base station and turn on the power supply.
For details of handling the base station, see the instruction
manual of the base station.
2.
Turn the starting switch to ON position (B).
Check that LED of the back grade mode switch lights up
for 3 seconds when turning the starting switch to ON posi-
tion.
If it does not light up, it may be defective such as open cir-
cuit.
Ask your Komatsu distributor for repair.
3.
Hold down the power ON/OFF and menu switch to turn on
the control box power.
REMARK
If the control box starts operation on the slope of which
pitching angle (inclination in front or rear) or rolling angle
(inclination in right or left) is 20 ° or more, accuracy of it
may deteriorate.
Start the control box on a level place.
3-16
OPERATION