Advertisement
PERIODIC MAINTENANCE AND MINOR REPAIR
EC000072
Tightening torque:
Engine oil drain bolt:
CAUTION:
e In
order
to
prevent
clutch
slippage (since the engine oil
also lubricates the clutch), do
recommended
engine
oil, and
not mix any chemical additives
then install and tighten the oil filler
with the oil or use oils of a high-
cap.
er grade than "CD", In addition,
do
not
use
oils
labeled
Recommended engine oil:
"ENERGY CONSERVING
II" or
See page 8-1.
higher.
Oil quantity:
@ Make sure that no foreign mate-
rial enters the crankcase.
43 Nm (4.3 m-kg, 31 ft-lb)
5. Add the specified amount of the
1. Engine oil drain bolt
To change the engine oil without oil
filter element replacement
1. Start the engine, warm it up for
several minutes, and then turn it
Without oil filter element
off.
. Place an oil pan under the engine
to collect the used oil.
. Remove
the engine oil filler cap
and drain bolt to drain the oil from
the crankcase.
. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
replacement:
3.0 L (2.64 Imp qt, 3.17 US qt)
With oil filter element
replacement:
3.1 L (2.73 Imp qt, 3.28 US qt)
Total amount (dry engine):
3.6 L (3.17 Imp qt, 3.81 US qt)
6-11
6. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
NOTE:
a
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
Advertisement
