Table of Contents
Advertisement
Figure 64. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink
2.
Install the air
shroud.
3. Follow the procedure listed in
Installing the processor heat sink module
Prerequisites
Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If installed, remove the processor dust cover.
Steps
1. Set the anti-tilt wires to the unlocked position on the heat sink (inward position).
2. Align the pin 1 indicator of the processor heat sink module (PHM) to the system board, and then place the PHM on the
processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
72
Installing and removing system components
module.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
