Sealey SDL13 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Hot surfaces
instructions
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
Familiarise yourself with the application, limitations and potential hazards of the device.
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Locate device in a suitable working area, keep area clean and tidy and free from unrelated materials.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the device clean for best and safest performance.
9
Ensure there are no flammable or combustible materials near the work area.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Wear heat resistant gloves and appropriate protective clothing.
9
Ensure the workpiece is adequately held before operating the device.
9
Always use the stand provided when not using the hot tool so that the tip cannot make contact with the work surface.
9
Always use device in a well ventilated atmosphere or alternatively wear respiratory protection.
9
Ensure that when the device is put down during use that the tip is not near to or in contact with any material that may burn or melt.
9
After use always keep the plastic welder in its original package in a safe place away from children.
9
DO NOT touch the tip during its warm up phase.
8
DO NOT use in wet or damp conditions.
8
DO NOT operate the device when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT leave the device hot and unattended. (If you are leaving the work area even for a short period of time switch it off and allow
8
to cool.)
DO NOT use the device for any purpose other than that for which it has been designed.
8
DO NOT allow untrained persons to operate the device.
8
DO NOT touch the workpiece as it will be very hot. Allow to cool.
8
DO NOT operate the device if damaged.
8
2. INTRODUCTION
Heats up to working temperature in just 15 seconds. Compact and lightweight design makes this device extremely portable. Ideal device for
working with plastic or 3D printed items. Maximum temperature of 400°C.
3. SPECIFICATION
Model No:................................................................... SDL13
Power Rating: ...................................................................8W
4. OPERATION
4.1. Once the usb is plugged in the tool will become hot.
DO NOT leave the tool unattended while it is hot.
8
4.2. Use the stand provided when placing the device on a work surface, being aware that it is not touching anything.
5. MAINTENANCE
Keep the tip of the tool clean while you work. Have a damp sponge handy to occasionally wipe your tip to keep it clean.
9
Properly cleaned tips are bright and shiny.
Never file the surface of the tip.
8
© Jack Sealey Limited
8W USB 3D PRINT FINISHING TOOL/PLASTIC
WELDER
MODEL NO:
Indoor use only Wear eye
protection
Original Language Version
SDL13
SDL13 Issue 1 16/07/2020