Mig welding is relatively easy to perform, but does require a steady hand. Only time spent practising will enable you to produce consistently good welds. Supermig250 is suitable for welding with CO2, Argon or CO2/Argon mix. It uses a forced air cooling system to slow transformer heating in order to increase duty cycle and a non-live torch to prevent the risk of accidentally striking an arc.
Tighten the screw, located in the centre of the wire spool holder (fig.4c), with a screwdriver and test the machine as above until the wire stops overrunning. Note: DO NOT overtighten the spool as this will cause wire feed problems and strain the motor. fig.5 Supermig250 Issue No: 1 - 03/03/09...
WELDING A VEHICLE, DISCONNECT THE BATTERY OR FIT AN ELECTRONIC CIRCUIT PROTECTOR. WE STRONGLY AS GUIDE ONLY RECOMMEND THE USE OF SEALEY PROSAF/12 OR PROSAF/24 IN ORDER TO PROTECT THE VEHICLE ELECTRONICS. ENSURE THAT YOU READ, UNDERSTAND AND APPLY THE ELECTRICAL SAFETY INSTRUCTIONS Wire 0.6mm Steel...
The gas cup must also be kept clean and free from spatter. Build up of spatter inside the gas cup can cause a short circuit at the contact tip which will result in either the fuse blowing on the printed circuit card or expensive machine repairs. To keep the contact tip free from spatter, we recommend the use of Sealey anti-spatter spray (MIG/722307) and a nozzle cleaning tool (AK107) available from your Sealey Dealer.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions, call us on 01284 757525 and leave your full name and address, including postcode. Sole U.K. Distributor 01284 757500 www.sealey.co.uk Sealey Group Bury St. Edmunds 01284 703534 sales@sealey.co.uk Suffolk.
Manufacturer and may be inspected, by a national We, the sole importer into the UK, declare that the product listed authority, upon request to Jack Sealey Ltd. below is in conformity with the following standards and directives. Signed by Mark Sweetman...