Right I/O-Board; Removing The Right I/O-Board - Dell MF6F1 Service Manual

2. Replace the screw (M2x3) that secures the left I/O-board to the palm-rest assembly.
3. Connect the power-button assembly-cable to the left I/O-board and close the latch.
4. Connect the antenna cables to the wireless card.
The following table provides the antenna-cable color scheme for the wireless card supported by your computer.
Table 3. Antenna-cable color scheme
Connectors on the wireless card
Main (white triangle)
Auxiliary (black triangle)
5. Using the alignment pins, connect the left I/O-board cable on the left I/O-board and the system board.
NOTE: The I/O-board cable is polarity sensitive. To prevent damage to your computer ensure that the MB UMT end of
the cable is connected to the system board.
6. Replace the two screws (M2x3) that secure the left I/O-board cable to the left I/O-board and the system board.
7. Place the wireless-card bracket on the wireless card .
8. Replace the screw (M2x3) that secures the wireless-card bracket to the left I/O-board.
9. Adhere the Mylar over the system board and left I/O-board.
Next steps
1. Install the battery.
2. Install the 2230 solid-state
3. Install the 2280 solid-state
4. Install the base cover.
5. Follow the procedure in

Right I/O-board

Removing the right I/O-board

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 2230 solid-state
4. Remove the 2280 solid-state
5. Remove the battery.
About this task
The following image indicates the location of the right I/O-board and provides a visual representation of the removal procedure.
34
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (if applicable)
drive. (if applicable)
Antenna-cable color
White
Black
computer.
computer.