Advertisement
NAMES AND USES OF PARTS
@ POWER indicator
Flashes rapidly for about 5 seconds after the power is
turned on until sound is produced, and flashes slowly in
the muting mode.
BALANCE control
Should normally be left in the center position. Adjust
balance if the sound is louder from one of the speakers.
If the right side is louder, turn toward the LEFT position,
and if the left side is louder, turn toward the RIGHT posi-
tion.
© VOLUME control/indicator
Use to adjust sound volume.
When operated by remote control, this control will rot-
ate with the knob indicator flashing.
Adjustment can also be performed with the accessory
remote control unit.
GRAPHIC EQUALIZER controls
These controls can be used to emphasize or de-empha-
size sounds in the frequency bands 100Hz, 330Hz, 1kHz,
- 3.3kHz, and 10kHz, thus allowing you to control tone
quality. The center position of each control is the normal
(flat) setting. When raised above the center position, the
contro! frequency band is emphasized; when lowered,
the band is de-emphasized.
G) EQUALIZER ON/OFF switch/indicators
When this switch is pressed, the GRAPHIC EQUALIZER
control's indicators turn on, and its functions become
operative.
When pressed once again, the indicators are turned off.
Use this switch in the following manner:
[ON]
: When
using the equalizer to add sound com-
pensation
while
performing
program
sources,
and
playing
back
and/or
recording
results.
[OFF] : When
not
using the equalizer,
but
playing
back
or
recording
program
sources
without
compensation.
NOTE
Equalizer ON/OFF indication is provided by a light on the
equalizer switch itself on U.S. and Canadian models, or by
control knob indicators on other models.
@ SPECTRUM ANALYZER
This display shows the condition of sound signals compen-
sated with the graphic equalizer controls.
(Because the level indicator is connected to the input side,
the indication does not change when the VOLUME control
is turned.)
@ FUNCTION indicators
These indicators light to show the setting of the FUNC-
TION switches.
STANDBY/SLEEP indicator
¢
This indicator flashes when
the accessory
remote
control unit is used to turn the SLEEP key. When the
SLEEP key is ON, the indicator will flash. (Initially it
will flash slowly, then gradually become faster.)
Sixty minutes after the sleep timer.is turned ON, the
power switch will be turned to STANDBY automati-
cally.
e This indicator lights when the accessory remote con-
trol unit or this unit is used to turn the POWER key.
(5) MUTING switch
Use to temporarily cut out all audio signals.
When the function is ON, sounds will be cut off. (POWER
indicator will flash)
When turned OFF, the sound returns to its previous level.
The muting ON/OFF function can also be operated by the
accessory remote control unit.
This component features a built-in microcomputer which will recall
the last-set positions of the following switches for up to about
several days after the power cord is disconnected. As a result, when
the power is turned ON again, the previously set positions will be
recalled auto matically:
e MUTING
switch
¢ FUNCTION switch
® EQUALIZER
ON/OFF switch
When the unit is not used for more than several days, the memorized
setting positions will be erased, and returned to the following
settings:
© MUTING switch ....cccccccceseseee cepa
Acute a aca OFF
© FUNCTION SwitcheS....ccccscccccccsscececonscscsesees TUNER
© EQUALIZER ON/OFF SWitch .....cccccececceccecseeceeess OFF
9
<ARB1160>
Advertisement
