Advertisement
OPERATIONS
RECORDING TAPES:
proper operating procedures.
PLAYBACK
TO USE THE COMPONENT CONNECTED TO
(2) Remove the two connecting bars from the
THE ADAPTOR
TERMINALS:
adaptor terminals.
Connecting
NOTE:
bars
Always remember to keep the connecting bars in place when these
terminals are not used.
(3) Connect the adaptor component in accor-
dance with the connection diagram in the
section "Connections."
[Operation]
(1) Playback the source.
(2) Operate the adaptor component.
The sound compensated with the connected adaptor
[Connection]
component
can be recorded on a tape deck. Signals
(1) Set the POWER switch to OFF.
modified with an adaptor component can be recorded
on a tape deck. However, surround sound from a sur-
round processing amp cannot be recorded.
NOTE:
:
Be sure to perform this operation with the adaptor component's
power switch in the ON position. Even when not using the adaptor
component, its power switch must be left ON. If the adaptor com-
ponent is switched OFF, no sound will be produced, or the playback
sound will be distorted.
For details, refer to the adaptor component's operating instruc-
tions.
13
<ARB1160>
Advertisement
