Makita 7104L Instruction Manual page 7

Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop.
WARNING:
Before plugging in the tool, always check
to
see that the trigger switch actuates properly
and returns t o the "OFF" position when released.
Operation
Grasp firmly the grips on either side.
Switch on the tool and wait until the
cutter chain attains full speed. Then release
the hook and lower the tool head to cut
in the workpiece. D o not apply excessive
pressure to the tool. This may not only
decrease the working efficiency but also
cause
a
dangerous reaction. Feed slowly
a t the beginning of a cutting operation, a t
the time of hole breakthrough and when
cuttina
a k n o t
in the workpiece. After cut-
-
ting, gently raise the tool head until you can hook the tool head back onto the hook.
Then switch off the tool. Raise the lever (A) and remove the tool from the workpiece.
WARNING:
0
Always hook the tool head back onto the hook when not operating the tool.
0
Never attempt t o cut a twisted or warped workpiece which the tool is not secured firm-
ly
to.
Adjusting indicator plate and indication plate
The yellow indicator plate and indication plate are factory adjusted for the standard-
equipped cutter chain 18 mm (23/32").
If
the alignment is
off, for
some reason, or
when using another size cutter chain, loosen the screws and adjust the yellow indicator
plate and indication plate.