Makita 7104L Instruction Manual page 10

When enlarging a hole both transversely
I
and longitudinally, c u t the holes in the
order indicated from No. ( 1 ) to
(6) as
shown. This makes for more easy and effi-
cient hole enlargement.
Front base
4
WARNING:
0Never attempt to enlarge a hole with the cutter chain still within the hole. This will
cause unstable and dangerous operation.
0
Never angle t h e cutter chain when cutting the first hole, or a dangerous kickback may
result. Always have t h e cutter chain set to the perpendicular position when cutting the
first hole.
Lap joints u p to 130 mm (5-1/8") can be
c u t with this tool.
NOTE
:
Lap joints can be c u t only on the front
(side away from you) of the workpiece.
10