Error Messages - Yamaha DTX Owner's Manual

Appendix — Error Messages

Error Messages

Too much MIDI data is being received in the buffer. Reduce the amount of data or insert intervals between the bulk
transmission and try again.
There is a data error in the MIDI data being received. Check if the sum of the bulk dump data being received does not
conform, or if the MIDI connections are looped. Check the MIDI cables and the data you want to send and try again.
The System Exclusive Receive parameter is not "on" when the bulk dump data is being received. Set the parameter on
the 11th page of Utility mode to "on" (P. 117) and try again.
The built-in memory back-up lithium battery is running low. Store the necessary data to an external device such as the
Yamaha MIDI Filer MDF2 and take the DTX to an authorized Yamaha Service Center to have the battery replaced.
You are trying to edit preset data such as the preset drum kit, preset style pattern or preset song, or you are sending the
bulk dump to a preset number. Select a user data area and try again.
Bulk dump data is being transmitted while the DTX is playing or recording a song or pattern. Stop the playing or
recording of the song or pattern and transmit the bulk dump data again.
Data already exists in the area you are trying to transmit the bulk dump data to. Clear the song or pattern (P.92, 109)
and try to transmit again.
You have received bulk dump data when you are not in Song Play Pattern Play mode, or when you have not stopped the
song or pattern you had been playing. This message also appears when the beat or number of measures you are copying
does not match those of the pattern or when the DTX is receiving erroneous bulk dump data. Correct the situation and
try again.
The song and pattern memory areas are full. Clear unnecessary songs or patterns (P.92, 109) and try again.
138