In Case Of Difficulty - Kenwood 1050CD Instruction Manual

In case of difficulty
Operation to reset
The microcomputer may fail into malfunction (impossibility to operate, erroneous dis-
play, etc.} when the power cord is unplugged while power is ON or due to an external
factor. In this case, execute the following method to reset the microcomputer and
return it to normal condition
Unpiug the power card from the power socket and
plug the power cord into the socket again.
Symptom
Cause
Remedy
No power is applied with the POWER
switch ON.
Power plug is loosely connected.
With the power plug connected to the
switched AC outlet of an amplifier, the power
of the amplifier is turned off
Insert the power plug firmly to the AC outlet
Turn the amplifiers power ON
Disc is loaded, player does not play.
Disc is loaded upside down
Disc is loose
Disc is dirty.
Disc is cracked
Condensation occurred on the optical Jens
unit
Load the disc again with its label side up.
Insert disc property.
Wipe off the dust on the surface of the disc
referring to "Disc handling precautions"
Replace the disc with a new one
Leave the player for about 1 hour so that the
condensation is removed
No sound.
Play mode 1s not entered.
Disc is too dirty.
Disc is cracked
The connection cords are inserted loosely.
Press the key.
Wipe off the dust on the disc surface refer-
ring to "Disc handling precautions".
Replace the disc with a new one.
Connect all connection cords firmly.
Music is interrupted. (Sound is
skipped.}
Disc is too dirty.
Disc is cracked
Oscillation is applied to this unit
Wipe off the dust on the disc surface refer-
ting to "Disc handling precautions"
Replace the disc with a new one
Try selecting a place where no strong vibra-
tions occur by changing the installation place,
ete,
Disc begins to play when power is
switched ON.
The CD player will automatically play when a
disc has been inserted and power is switched
ON
To avoid disc playing automatically, remove
disc before switching off power.