Timer Operation.15; In Case Of Difficulty - Kenwood DP-R895 Instruction Manual

Timer operation
The unit has the timer stand-by function.
With this function and commercialiy-available audio timer^ playback can be started at the desired time.
/-
^
Connect the power cord.
• Connect each unit's power cord to the SWITCVIEO outlet of
the timer
■ ■ ■
• Refer to the instruction mamjal of the timer.
Wall AC outlet
Connect to the SWITCHED outlet.
2 Turn on the amplifier and the unit.
3 Insert a disc and set the starting time of the timer.
• Set the timer while the unit and the amplifier are ON.
• Piayback starts at the set time.
• Be carefu! of the volume setting of the amplifier. <The loud sound may damage the speakers.)
Note:
When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.
In case of difficulty
When appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
Symptom
Cause
Remedy
IMo power is applied with the POWER
switch OW.
• Power plug is loosely connected,
• With the power plug connected to the
switched AC outlet of an amplifier, the
power of the amplifier is turned off.
m
Insert the power plug firmly to the AC
outlet.
• Turn the amplifier's power ON.
Disc is loaded, player does not play.
• Disc is loaded upside down,
• Disc is loose,
• Disc is dirty.
• Disc is cracked,
• Condensation occured on the optical lens
unit
• Load the disc again with its label side up,
• Insert disc properly.
• Wipe off the dust on the surface of the disc
referring to "Disc handling precautions".
• Replace the disc with a new one.
• Leave the player for about 1 hour so that
the condensation is removed.
No sound.
• Disc is not loaded.
• Play mode is not entered (The play/pause
indicator is not lit).
• Disc Is too dirty.
• Disc is cracked,
• The connection cords are inserted loosely.
• Load a disc and press the PLAY/PA USE key
[ZZH].
• Press the PLAY/PAUSE key 1 ►Mil.
• Wipe off the dust on the disc surface
referring to "Disc handling precautions".
• Replace the disc with a new one,
• Connect all connection cords firmly.
M usicis interrupted. (Sound Is skipped.)
• Disc is too dirty,
• Disc is cracked.
• Oscillation is applied to this unit,
m
Wipe off the dust on the disc surface
referring to "Disc handling precautions".
• Replace the disc with a new one.
• Try selecting a place where no strong vibra¬
tions occur by changing the installation
place, etc.
Disc begins to play when power is
switched ON.
« The CD player will automatically play when
a disc has been inserted and power is
switched ON.
• To avoid disc playing automatical !y, remove
disc before switching off power.
Notes:
1. This system is microprocessor-controlled, so malfunctionmay occur due to externa! noise or interfere nee noise. In such a case, unplug the power
cord, plug it and turn power on again,
2, Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform
the plastic components.
DP-RS95lEn) 15
.