Kenwood KR-A5070 Instruction Manual page 20

Fm /am receiver
Hide thumbs Also See for KR-A5070:
Table of Contents

Advertisement

KR-ASO70/KR-A4070 (En)
Preparation
~ (18)
e Tune
the
station
to
be
stored
in
memory.
(Station preset) __
Pe
san
a
a
ni ae
ae
EERE ONE
PM MADE NES
Lights up (for 5 sec.)
Proceed to step 2 within 5 sec.
|
"
"(if more than 5 sec. have elapsed, press the MEMORY key again.)
PP eer
r eT rer rrr rer rir
servi riirert ri reser ri ret eter rie eree ere reer err
tere err rrr ri rier rit rsi erie terre etre rss
e@ Up to 10 stations can be preset for each broadcast band.
@ Repeat steps 1 and 2 for each of the stations to be stored in
memory,
e lf a station is stored in a preset number which already stores a sta-
tion memory under it, the previous memory is replaced by the new
memory content.
@ Once the memory content has been preset, it is held for about 3
days even after the power cord is unplugged from the mains outlet.
2 Select one of the preset numbers from 1 to 10.
@
10/0
ew Ff
bias
Each press swiiches the band as follows:
OFM 1
@FEM 2
@ AM
Each press switches the band as follows:
® FM 1
@FM 2
@) AM
The preset stations are received
in the following order.
in FM band: (FM 1) 1-*2...9-+10-*(FM 2)1-2...9-+10-+(FM
1)1...
tn AM band: (AM}
1-*2...9-+10~ 1-+2...
e To stop preset call operation, press the P.CALL key again. The pre-
set station being received when the key is pressed will continue to
be received.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kr-a4070

Table of Contents