Table of Contents
Advertisement
The camera's video will overlay warning text on the video image: SD Card Recording
l
Disabled! Replace card to re-enable.
Note: The video overlay message can be disabled on the camera's Storage page by clearing
the Enable video alert overlay on severe SD card failure checkbox.
The camera's Storage page will have a warning message when you select the page: SD card slot
l
was disabled due to card errors, please replace card.
To re-enable the SD card, remove it from the SD card slot on the camera and replace it with a working SD
card. A speed test will be run on the new card when it is inserted to determine if it will function without any
issues.
You can also force the SD card to be re-enabled in the web interface by clicking Force Re-Enabled SD Card
Slot on the Storage page.
Important: Forcing the SD card to be re-enabled is not recommended unless you are sure there are
no problems with the card. If the card continues to fail, it may cause the camera to enter a reboot
loop and after continued persistent failures, the SD card will be disabled again.
Digital Inputs and Outputs
On the Digital Inputs and Outputs page, you can set up the external input and output devices that are
connected to the camera. This option does not appear for cameras that do not support digital inputs and
outputs.
1. To configure a digital input:
a. In the Digital Inputs area, enter a name for the digital input in the Name field.
b. Select the appropriate state from the Circuit State drop-down list. The options are:
Normally Open
l
Normally Closed
l
Note: Some cameras can detect the circuit state of the digital inputs automatically and
the input will trigger when a change in state is detected. For these cameras, the Circuit
State setting will have no effect on the digital input function.
c. The Type drop-down list is used for cameras that can have the day/night mode triggered by an
external light detector. You will only see this option on cameras that support this feature. If the
digital input will be used to control the day/night settings, select Force IRCF in the Type drop-
down list.
Digital Inputs and Outputs
29
Advertisement
Table of Contents
