Table of Contents
Advertisement
1. In the left-menu pane, select Network > SNMP.
2. On the SNMP page, select the Enable SNMP check box.
3. From the Version drop-down list, select the preferred SNMP version. Be aware that both versions can
be configured, but only one can be enabled at a time:
SNMP v2c: Using SNMP v2c, you can make a request to the camera for status information
l
through an SNMP Get request and receive trap notifications from the camera.
In the SNMP v2c Settings area, select the Enable Traps check box to enable traps from the
camera.
a. Read Community: enter the read community name for the camera. The name is used to
authenticate SNMP traffic. Only SNMP management stations with the same read
community name will receive a response from the camera.
b. Trap Destination IP: enter the IP address of the management station where the traps
will be sent.
In the Available Traps area, select the traps that will be sent:
SNMP v3: Using SNMP v3, you can request status information through an SNMP Get request.
l
SNMP v3 does not support traps.
SNMP v3 offers greater security by allowing you to set a username and password for the
camera. This camera uses SHA-1 type authentication and AES type encryption.
In the SNMP v3 Settings area, complete the following:
a. Username: enter the username that the management station must use when sending
the SNMP Get request to the camera.
b. Password: enter the password the management station must use with the chosen
username.
4. Click Apply to save your changes.
IP Filter
On the IP Filter page, you can control which IP addresses are able to connect to your camera.
If enabled, you have the option to limit IP addresses in 2 ways:
Deny Access to specific IP addresses or range of addresses.
l
Allow Access only to specific IP addresses or range of addresses.
l
IP Filter
Temperature Alert: a trap notification will be sent when the camera temperature
o
rises above or falls below the supported threshold. A notification will also be sent
when the camera temperature returns to normal.
Camera Tampering: a trap notification will be sent when the camera's video
o
analytics detects a sudden scene change.
Edge Storage Status: a trap notification will be sent when the status of the SD
o
card changes.
IR Illuminator Status: a trap notification will be sent when the status of the H4
o
multisensor camera's IR LED ring changes.
12
Advertisement
Table of Contents
