Cub Cadet LTX1046 Operator's Manual page 28

5. To place the new belt begin by routing the belt around the
two outer spindle pulleys as shown in Fig. 7-8.
6. Then route the belt around the two deck idler pulleys as
show in Fig. 7-8.
7. Retighten the belt keeper rod loosened earlier.
8. Remount the belt guards removed earlier.
9. Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
10. Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-9.
11. While holding the belt and pulley together, rotate the
pulley to the left (See Fig. 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
28 s 7— s
ectiOn ervice
Figure 7-8
PTO Belt
Rotate
Pulley
Figure 7-9