Kenwood KT-5020 Instruction Manual page 6

System connections
Make connections as shown in the diagram below.
Do not plug the power cord into the wall outlet until all connections have been completed.
FM indoor FM outdoor
antenna antenna
300 ohm
feeder
75 ohm |
coaxial I
1 bl I
CI Jere aor il
if
he jen 75 ohm/300 ohm —
! I cal antenna adaptor e
LLU
ANTENNA
FM7SQ Mf
AM loop antenna
il
ey
were
AM loop antenna
Speaker
Adjust the direction
of the loop antenna
so that reception is
optimized.
M@ System operation
@ System operation via system control connection with
an amplifier. ;
The SYSTEM CONTROL jacks on KENWOOD amplifiers
are marked with either "XQ" or " XS".
By connecting the SYSTEM CONTROL jack of this unit
with that of a KENWOOD amplifier, the following system
Operations are possible.
When connected to an "OQ" jack: This unit can be
controlled as part of the entire system with the remote
contro! unit provided with the amplifier.
When connected to an "(XS)" jack: This unit can be
controlled as part of the entire system with the remote
control unit provided with the amplifier for easy operation,
For details, refer to the instruction manual provided with
your amplifier.
fH = KT-5020 (En)
[ Except for
some areas.
I
1
i
Right
Amplifier
AM outdoor antenna
When this unit is combined with an amplifier
having KENWOOD SYSTEM CONTROL termi-
nals, system operations such as remote contro!
as a system is made pessible. For details, refer
to the instruction manual of the amplifier.
lf your amplifier or receiver is not equipped
with the SYSTEM CONTROL terminals, do not
connect anything to any SYSTEM CONTROL
terminals.
Do not connect the unit in any system contig-
uration other than specified.
Audio connection
cord supplied
Left
To AC outlet
Speaker
Notes:
1. Be sure that all the connecting cords are connected properly.
If they are not, the sound may not be procuced or there may
be noise interference.
2. When taking out and putting in the connecting cords, be sure
to turn the power of this unit OFF and turn the amplifier's
voiume to minimum. If this is not done, it can lead to errors in
functioning.
@ AM loop antenna setting
Insert the supplied AM loop indoor antenna into the
supplied loop antenna stand.
Place the stand ona stable surface, for example ona shel,
or install it on a rack or wall with wood screws.
Note:
Place the AM loop indoor antenna as apart as possible from the
TV, speaker cords, power cords and system control cords.
@ AM outdoor antenna
In steel buildings or at a great distance from the transmit-
ter, it may be necessary to install an outside longwire
antenna. The end of this wire should be stripped of
insulation and connecied to the AM terminal. At this time.
keep the loop antenna connecied,