Table of Contents
Advertisement
Questions and Troubleshooting
(5) Cleave angle is too large / Cleave shape is not good
Dust or dirt may be on the cleaver blade and insert. Refer to the [Daily Maintenance] and
[Loading Fiber into the Cleaver] section and clean them.
There is a possibility of improper [Cleave Tension]. Adjust the [Cleave Tension] by editing
the [Tension Setting].
The cleaver blade may be worn out. Execute [Blade Position Change] in the
[Maintenance Menu]. If all of the blade positions have been used, execute [Blade
Replacement] in the [Maintenance Menu].
If the backstop is used, confirm that it is properly positioned. If the backstop is dusty or
dirty, clean it. *Refer to the [Daily Maintenance] and [Loading Fiber into the Cleaver].
Clamp force may be improper/insufficient. Adjust the [Left/Right Clamp Force] by editing
the [Cleave Mode].
The height of the lower insert may be improper. Adjust the height of the lower insert with
reference to the [How to replace Insert and Shim] section.
Setting [Left Clamp Position] larger may improve the cleave angle / cleave shape.
Setting the [Clamp Mode] to "Left -> Right" may improve the cleave angle / cleave
shape.
Supervisor Settings
(1) What functions can be disabled?
See the [Menu Lock Settings] section.
(2) How to lock selection or editing of a Cleave mode
See the [Menu Lock Settings ] section.
(3) Forgot password
Contact the authorized distributor.
Other Functions
(1) The screen is too dark.
Press the DOWN key in the [READY] state to adjust the brightness.
CT114_Rev
2
77
Advertisement
Table of Contents
