Table of Contents
Advertisement
Settings
Rinse aid
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6 ml.
3 ml is the factory default setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the pro-
gramme.
If spots appear on crockery and glass-
ware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
- Decrease the rinse aid dosage.
Save Extras
You can set whether the selected extras
are to remain permanently activated for
the respective programme.
For the ECO programme, an extra can
only be activated for one programme
sequence.
34
Consumption display
(EcoFeedback)
You can set whether the energy and
water consumption is displayed for the
selected programme. This function
shows the estimated consumption be-
fore a programme sequence and the
actual consumption after the end of the
programme (see "Caring for the envir-
onment – EcoFeedback consumption
indicator").
Display brightness
You can set the display brightness to
one of seven different levels.
Buzzer
A buzzer sequence will sound at the
end of a programme or if there is a fault
as long as the buzzers are activated.
The buzzers at the end of the pro-
gramme and the alarm tone in the event
of a fault will sound 4 times at intervals
with a short pause between each set.
You can activate or deactivate the
buzzer that sounds at the end of the
programme if you wish.
The alarm tone that sounds when
there is a fault cannot be deactiv-
ated.
Advertisement
Table of Contents
