Think Safety - Bosch GSR18V-800FC Operating/Safety Instructions Manual

in connector, remove the rubber nozzle from
the dust extractor hose. Press the snap-in
connector into the dust port until you hear
the click.
Dust port adaptors are also available to con-
nect the Bosch dust extraction attachment
to any common size dust extractor hose. See
Boschtools.com for details.
Turn the dust extractor on and place the at-
tachment on the wall (or the floor), over the
desired drilling location so that the center of
the hole lines up with the center of the open-
To reduce the risk of injury read the operating instructions included with
Bosch GCY42 connectivity module. Operating instructions for GCY42
connectivity module include important information not covered in this manual.
Bluetooth®
Do not use the power
tool with Bluetooth® in
the vicinity of gas stations, chemical plants,
areas where there is danger of explosion
and areas subject to blasting. Do not use
the power tool with Bluetooth® in airplanes.
Do not use the power tool with Bluetooth®
in the vicinity of medical devices. Avoid op-
eration in the direct vicinity of the human
body over longer periods of time. When us-
ing the power tool with Bluetooth®, interfer-
ence with other devices and systems, air-
planes and medical devices (e.g., cardiac
pacemakers, hearing aids) may occur.
The Bluetooth® word mark and logos are reg-
istered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by Robert
Bosch Tool Corporation is under license.
Follow
and warnings provided
by your Bluetooth® device manufacturer.
Failure to follow recommended procedures
could result in personal injury or property
damage.
Exercise extreme caution
when using Bluetooth®
devices to control or change power tool
functions. Operation of the device may be in
a different area than the paired power tool.
24
2610070415 GSR18V800FC 202310.indd 24
Dust Extraction
ing of the brush ring. Note: the suction from
the dust extractor will hold the attachment in
place on the work surface. Place the drill bit
through the opening in the brush ring in the
desired drilling location and drill the desired
hole (Fig. 23). Follow all tool safety and oper-
ating instructions.
Note: for best results, continue running the
tool even when removing the bit from the
hole. The combination of the vacuum with
the spinning motion of the bit helps remove a
majority of the dust from the hole.
Connectivity
Paired devices may have functionality which
allows timed event programming, including
automatically powering on (e.g. flood light).
Depending upon the power tool, these unat-
tended operations or function changes with-
out direct line of sight to the paired tool
could result in personal injury or property
damage.
be different than when the tool was last
used. The connectivity module enables trans-
fer of data and settings based on Bluetooth®
wireless technology. With module installed,
select tool settings may be changed remotely
by a paired Bluetooth® device and user in-
stalled app.
radio interface. Local operating restrictions,
e.g. in military sites or hospitals, are to be
all instructions
observed. Transmitters have demonstrated
an ability to unintentionally interfere with
other devices.

Think Safety

SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TOOL IS BEING USED.
Always check tool settings
before use. Settings may
The connectivity module
GCY42 is equipped with a
10/24/23 3:15 PM