User Interface - Bosch GSR18V-800FC Operating/Safety Instructions Manual

User Interface

(Fig. 20)
STATUS INDICATOR LED
The LED bar at the top of the user interface
illuminates in various colors to help the user
identify the status of the tool.
• When the Status Indicator LED 10a is
green the tool and battery pack are operat-
ing normally and temperatures are ok.
• If the indicator changes to yellow it means
that the tool or battery temperatures have
risen to a critical level. It is best to back
off the load and give the tool a chance to
cool down.
• If the indicator turns red the tool will shut
off to protect itself and/or the battery pack
from an overheating situation.
• The Status Indicator LED 10a will also
blink blue when the Precision Clutch Over-
ride 10e or KickBack Control 10c buttons
are held for 7 seconds. This will reset the
tool settings to factory default.
KICKBACK CONTROL (RAPID SHUT-OFF)
To ensure better control of the tool
during operation, this tool is design
to shut-off while in use if a sudden or
unexpected bind up situation occurs. Bind
up occurs when the bit gets jammed during
operation, which forces the bit to stop spin-
ning abruptly. If this occurs, the tool will shut
down and the KickBack Control will be indi-
cated by flashing LED lights on the tool.
KickBack Control can be turned off by the
user. Button 10c on the User Interface 10
will toggle the feature on and off. Status is
indicated with "On" and "Off" LEDS 10b on
the User Interface 10. If the power tool is not
used for longer than 5 minutes, or if the bat-
tery is removed, KickBack Control automati-
cally turns back on.
Please note that the indicator light may not
be visible from all directions or in bright sun-
light.
When the switch trigger is pressed, operator
is notified about the KickBack Control status
via HMI light.
22
2610070415 GSR18V800FC 202310.indd 22
Operating Instructions
(a)
(f)
(e)
PRECISION CLUTCH OVERRIDE
This tool features an adjustable clutch with
output torque increasing as the clutch ring
is rotated through the settings from 1 to 20.
By default, at a given torque setting, the tool
senses when the clutch begins to slip, and
automatically shuts off the motor thereby re-
ducing wear and tear on the clutch as well as
the resulting noise. This is called Precision
Clutch.
This automatic shut-off can be overridden by
pressing the "P-Clutch" button 10e on the
foot of the tool so that the "off" indicator 10f
lights up. In this mode, the motor will con-
tinue to run whenever the trigger is pressed
regardless of any clutch slippage.
BUILT IN LED WORK LIGHT
Your tool is also equipped with an LED light
10d that turns on automatically when the
switch is activated, for better visibility when
drilling/ driving. The light turns off automati-
cally a short time after the trigger is released.
You can adjust this time frame using Bosch
Tool Box app. See "Connectivity" section.
Fig. 20
(10)
(b)
(c)
(d)
10/24/23 3:15 PM