Whirlpool GLADIATOR STEEL MODULAR THREE-DRAWER CABINET Assembly Instructions Manual page 4

Assemble Drawers
F3c Phillips-head screw (45-black)
IMPORTANT: When assembling the drawer, make sure the drawer
sides (D1) and (D3) are positioned so that the glides are near the top
and facing outward.
1. Place the drawer bottom (D4) on a flat, firm surface, so that the
tabs are pointing up.
NOTE: The long side with holes is the front edge of the drawer
bottom.
2. Lay drawer side (D3) flat on top of the drawer bottom (D4), so
that the tabs are alternating.
3. Slowly lift up on the drawer side (D3) until the side is upright and
the tabs are interlocked as shown.
D4
D3
D4
4. Repeat steps 2 and 3 to assemble the opposite drawer side (D1).
D1
4
F3c
D4
D3
D4
D3
5. Lay the drawer back (D2) flat on top of the drawer bottom, so
that the tabs are alternating. Slowly lift up on the drawer back
until it is upright and the tabs are interlocked.
6. Working from inside the drawer, insert the six screws (3 on each
side) through the drawer back (D2) and into the flanges of drawer
sides (D1 and D3).
NOTE: To allow for adjustment when inserting the drawers into
the cabinet do not completely tighten the screws.
D1
D2
D1
A
7. Stand the drawer on its back (D2) so that the drawer bottom (D4)
is facing you.
8. Position the drawer front (D5), so that its side flanges are inside
the drawer sides (D1 and D3), and its bottom flange is under the
drawer bottom (D4).
D1
9. Using nine Phillips-head screws (F3c), fasten the drawer front to
each side and the bottom (3 screws each).
D2
A
D1
A. Drawer glide lever
B. Phillips-head screws (F3c)
D2
D4
D3
D5
D4
D3
D5
B