Whirlpool GLADIATOR STEEL MODULAR THREE-DRAWER CABINET Assembly Instructions Manual page 3

Tools Needed:
¹⁄₂" Wrench
³⁄₈" Wrench
Phillips screwdriver
Tools Supplied:
Hex key
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet, make sure the edges with the
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six internal hex-head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2), for
the two middle holes only, as shown. Do not tighten completely.
4. Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).
5. Align the holes and attach the top (P2) to the side (P3) using six
internal hex-head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2), for the
two middle holes only, as shown. Do not tighten completely.
6. Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up and that
the threaded posts are standing up on the inside of the unit as
shown.
7. Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using12 internal hex-head bolts (F1) and four ⁵⁄₁₆"
flange nuts (F2), for the four middle holes only, as shown.
P1
P2
Pliers
Level
Tape measure
P4
P3
P2
P3
8. Square the cabinet frame. The measurements from corner to
corner should be equal distance.
P1
P2
9. Using the hex key (provided), completely tighten the bolts.
Measure the frame again to make sure it is still square.
Install Leveling Legs or Casters
The Gladiator ® Modular Cabinet is designed to be either stationary or
to roll on casters.
IMPORTANT: If you decide to install the casters on the cabinet, see
the installation instructions included with the caster kit (provided).
To install leveling legs:
1. Place the cabinet on its side.
2. Screw a leveling leg (P7) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P6
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.
P4
P3
P7
P4
A
3