Operation; Loading Compact Discs - Kenwood KDC-C600 Service Manual

a
KDC-C600
OPERATION
@ Be sure to turn the screw on the bottom of the unit according to the changer's
instalation orientation (horizontal or vertical).
(The spring is set for horizontal installation when the unit is shipped from the
Bottom view
factory.)
'(a CAUTION
ie The screw will not
la (®)
1
turn any further
| once it locks
@ If the screw is v
turned with the
magazine inserted,
the unit may be damaged
Be sure to eject the
magazine before turning the
screw
Turn the screw while
pushing the screwdriver
[lightly
it: z
®@ Vertical installation
(Turn the screw 180° to the left.)
Claw
Turn the screw to
the left until it stops.
(Claws are observed
through the stot.)
® Horizontal installation
(When switching from a vertical to horizontal installation, turn the screw 180° to
the right.)
Turn the screw to
the right until it
stops.
LOADING COMPACT DISCS
isc"
mark
facing up
To remove
Labeled surface
10 discs, one in each stot
@ To remove a disc from the
magazine, press on the rear of the
disc so that it slides out the front
Do not use too much force or the
disc may fly out the front of the
magazine.
@ Discs are number in sequence (1, 2,
3...) from the bottom slot up. Insert
discs into the magazine with their
labeled sides facing up.
A CAUTION
8 cm (3in) CDs cannot be used in this unit. If an 8 cm (3 in} CD adapter ts
used, the disc will not eject
@ insert the disc magazine into the
unit.
® Open the door of the unit
insert the disc magazine titl it clicks.
£JECT switch
® To remove the disc magazite, Open
the door and then press theeJ ECT
switch.
The magazine will not eject if the dior 1s not
completely open.
@ Oust entering the unit will make the
laser pickup dirty and adversely
affect performance. Always be sure
to keep the door closed.
A CAUTION
< When using a new disc >
@ Before using a new disc, be sur t@ check
for burrs around the edges of th chisc's
center hole and outer circumfernc e (see
diagram at left). If burrs are preent, use a
ballpoint pen or similar instrumeit tO
remove them. If a disc is used with burrs
stil attached, the disc may not it poroperly
im the player or disc magazine, « t he sound
may tend to skip during playbac
Center hole
ye Outer edge
< Disc accessories >
© There are several types of disc accessories 'stabilizers, protective seals, es,» on the
market designed for various purposes such as sound quality improvemenian d disc
protection. Use of such disc accessories w:li change the thickness or outs
dimensions of the disc with the result that ihe disc will not conform to Stn ard
specifications. Discs with this type of accessory altached may cause the jgc> Changer
io malfunction and shouid therefore not be used with this unit