Replacing The Battery Pack; Cleaning And Maintenance - Siemens SIMATIC RTLS4084T Operating Instructions Manual

Operating the transponder
The transponder is operated with the F1 and F2 function keys on the front panel. The
function of the keys can be programmed via the programming interface.
The internal voltage of the transponder is displayed in the Locating Manager. The nominal
voltage of 14.4 Volt indicates that the battery pack is fully charged. If the value is less than
12.0 Volt, the battery pack is empty and must be replaced.
3.2

Replacing the battery pack

To replace the battery pack, follow these steps:
1. Loosen the screw of the battery box cover on the rear of the transponder with a Phillips
screwdriver.
2. Remove and disconnect the empty battery pack.
3. Plug in the new battery pack and place it into the enclosure.
4. Then close the enclosure again, making sure that the sealing ring on the screw is positioned
correctly. Recommended tightening torque for the screw is 0.4 Nm.
5. Make sure that the connecting cable is positioned correctly so that it is not crushed when
you close the battery box cover.
Note
The batteries of the transponder should only be changed in dry environments.
Note the following when replacing batteries
• Do not insert a damaged battery pack.
• Batteries inserted with reverse polarity cannot be reused.
3.3

Cleaning and maintenance

The enclosure may only be opened to change batteries.
The transponder may only be repaired or opened for other types of work by an authorized
maintenance company.
Improper opening or repair of the transponder may result in serious risks for the user.
Opening the transponder without permission renders the warranty of the Siemens AG null
and void.
Do not clean the enclosure with liquids or abrasive, caustic or flammable cleaning products.
SIMATIC RTLS4084T
Operating Instructions, 05/2023, C79000-G8976-C626-04
CAUTION
Installation & operation
3.2 Replacing the battery pack
15