Husqvarna DC 2-48 Operator's Manual page 22

3. Set the drive speed to the lowest possible,
approximately 0.5.
4. Open the drive chain cover.
5. Install the quick-release pin. Push and hold the
quick-release pin with a finger.
22
6. Use your other hand to operate the drive system
lever.
The quick-release pin locks into position when the
drive system is engaged.
7. Close the drive chain cover.
8. Turn the height adjustment handles to lift the casters
until the drive system is on the ground.
9. To disengage the drive system, refer to
disengage the drive system on page 22 .
To disengage the drive system
CAUTION:
system when the product is parked on level
surface.
If it is necessary to move the product manually with the
motor off, the drive system must be disengaged.
To
Only disengage the drive
2121 - 002 - 04.07.2023