Table of Contents
Advertisement
4 Z-Wave Network Setup
SmartStart Learn Mode
SmartStart-enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code
present on the product with a controller providing SmartStart inclusion. No further action is required and
the SmartStart product will be added automatically within 10 minutes after this product being powered
on in the network vicinity.
Manual Setup
1. Follow the user guide of your Smart Hub or Panel to enter Learning or Pairing mode.
2. Add the lock to your Z-Wave network
Press
2 times
1
Press
3. Remove the lock from your Z-Wave network
Press
2 times
2
Press
Attention
If the lock is connected to a network controller, it is recommended that all programming of PIN codes and settings is completed
through 3rd party user interface to ensure stable communication between the lock and controller is maintained.
18
Enter Master
PIN Code
1 time
Press
Green light is on
Enter Master
PIN Code
Press
1 time
Green light is on
Press
1 time
Green light is on
Press
1 time
Green light is on
0
Press
0
Press
Advertisement
Table of Contents
