Table of Contents
Advertisement
6. Program Function Options Setting
6.1 Description of This Function
This function can remove display of the following functions from the initial setting screen and user setting screen. Setting of func-
tions can be customized for each object.
Function
Charge function
General PLC functions
IC I/O signal function
Energy saving function
Peak cut function
Trend function
Night mode function
Auto-changeover function
Note:
- The initial value is set to all [No function (OFF)].
- Functions can be made optional by using this function.
- When upgrading from version 2.00 on a system with meter function, the meter function remains in effect even after the
upgrade.
6.2 Setting Screen Switching
Function options setting screen switching
The following describes how to switch the function options setting screen from
the TG-2000A started state.
[Procedure]
1) Select Configuration - System Set from the menu bar
Click Configuration on the Management screen menu bar. The password
confirmation screen opens.
2) Enter the password
Enter password at the password confirmation screen, and click the OK but-
ton. The initial screen opens.
Note:
- The password initial value is "SYSTEM". The password can also be changed.
Contents
Displays the air-conditioning charge or
ratio result for each block and watt hour
meter.
Used to monitor and operate general
equipment (PLC). Select this function
when using a general PLC.
Used to monitor and operate general
equipment (IC I/O signal)
Used to control temperature shift,
thermo off, and other energy-saving
settings.
Peak cut control is used to change
control settings based on power level as
well as to monitor the watt-hour meter
connected to the PLC.
Display trend history of data such as
peak-cut status, power level, suction
temperature, temperature settings,
On/Off status or mode.
By setting the start and end times of
night mode, it is possible to run specified
outdoor units at night time in night
mode.
Able to switch automatically between
cooling and heating according to the
difference between the setting
temperature and the intake temperature.
This function is also valid for models that
support manual switching.
16
Remarks
❈ Requires separate general use
control software.
❈ Not available when peak cut function
is operating.
❈ Includes energy-saving function.
❈ Automatically selected when peak cut
function is operating.
❈ This can be set for each outdoor unit.
Switching screen to options setting
Advertisement
Table of Contents
