QRP Labs QMX Operating Manual page 85

Q9: Get/Set IQ Mode
Set: Set IQ Mode: 1 enables IQ Mode, 0 disables IQ Mode. In IQ Mode, the raw I & Q samples
from the ADC are streamed directly to the USB Sound card. The setting is for the current
operating session only and is not written to EEPROM.
Get: Get IQ Mode; 1 = Enabled, 0 = Disabled
QA: Get/Set Japanese Band Limits mode
Set: Set Japanese Band Limits mode: 1 enables Japanese band limits, 0 disables Japanese band
limits. In Japanese Band Limits mode, QMX cannot transmit outside the allowed Japanese
band limits. The setting is for the current operating session only and is not written to EEPROM.
Get: Get Japanese Band Limits mode; 1 = Enabled, 0 = Disabled
QB: Get/Set CAT timeout enable mode
Set: Set CAT timeout enable. 1 enables CAT timeout, 0 disables CAT timeout. When enabled, if in
transmit mode, if there is no CAT command for a specified timeout, QMX automatically returns
to receive mode.
Get: Get CAT timeout enable mode; 1 = Enabled, 0 = Disabled
QC: Get/Set CAT timeout
Set: Set CAT timeout. Specifies the CAT timeout in seconds.
Get: Get CAT timeout. Returns the CAT timeout in seconds
QJ: Get/Set TX shift threshold
Set: Set TX shift threshold (see explanation in Configuration screen description section of this
manual)
Get: Get TX shift threshold
RD: Set negative RIT offset amount
Set: Sets negative (down) RIT; for example "RD-200;" sets the RIT to -200Hz
RT: Get RIT status
Get: Returns RIT status: 0 = RIT off, 1 = RIT on
RU: Set positive RIT offset amount
Set: Sets positive (up) RIT; for example "RD150;" sets the RIT to 150Hz
RX: Set the radio into Receive mode immediately
Set: Command RX; immediately puts the radio into receive mode. It is equivalent to TQ0;
SP: Get/Set Split mode
Set: Sets Split mode: 0 = OFF, 1 = ON. For example "SP1;" switches QMX to split mode
Get: Returns the Split state: 0 = OFF, 1 = ON.
QMX operating manual; firmware 1_00_012
85