Panasonic KX-G8300 Service Manual And Technical Manual page 13

KX-G8300
6. Remove the four screws from the cable clamping plate.
7. Remove the rubber gasket.
8. Remove the transmitter cover after removing the six screws.
Cautions: Do not touch anything inside the transmitter cover. Do not arrow any iron or steel items to come near
the magnetron.
Six Screws
Four Screws
Cable Clamping plate
Rubber Gasket
Transmitter Cover
9. Run the cable through the hole at the bottom of the antenna unit through the rubber gasket and through the cable
calmping plate and connect the four plugs from the cable to the jacks as follows.
© 2-pin plug to CN 604 on the receiver PCB
@ 9-pin plug to CN 602 on the receiver PCB
@ 4-pin plug to CN 805 on the transmitter PCB
¢ 7-pin plug to CN 803 on the transmitter PCB
7)
2-Pin Plug
9-Pin Plug
\
@
7-Pin Plug
4-Pin Plug CN 602 (9-pin)
CN 604 (2-pin)
Rubber Gasket
Fig. 11