Setting The Sleep Timer - Sanyo R227 Instruction Manual

5. Turn the knob until the display says <Set Time>.
< SetTime/Date >
6. Before setting Time and Date, you need to choose the correct time zone. There are 7 time
zones to choose.
7. After setting the time zone, you need to set the time.
8. Pressthe SELECT button,
Set Time
10:30 AM
9. Turn the knob until the hour setting is correct, then press the SELECT button.
Set Time
10:03 AM
10.Turn the knob until the minute setting is correct, then press the SELECT button.
Set Date
01 Jan 2008
11.Then we can continue to set the date, month and year.
Finally, the display returns to the Set Time/Date mode.
After finished setting, when the unit is turned on, the time information will always show on
bottom right hand corner of the display. When the unit power is off, the time information will
show in the middle of the display at its maximum size.
Setting Sleep Timer
Selecting this option will enable the radio to switch itself off after a set period.
1. Press the Sleep button, the display will show "Sleep Timer 15 minutes" and the radio will
continue to play as normal for 15 minutes and go into standby mode automatically.
2. To increase the amount of time that the radio will play before shutting off, press the Sleep
button again to change the display to the desired sleep time. When Sleep button is pressed
each time, the sleep timer prolongs 15 minutes, up to a maximum of 90 minutes.
3. To turn the radio on again, simply press the Standby button.
US-21