Sanyo R227 Instruction Manual page 12

REMOTE CONTROL BATTERY
1.
Note: Remove the battery from the remote control if
пої їп use for a long period of time. When the battery
becomes weak, the remote control will not function
properly. Replace with new battery.
** Battery Included **
Press firmly on the battery cover and then rotate
it in counter clockwise direction, the cover will
come off. CTA,
Place the battery (CR2032) into the battery
compartment according to the polarity markings,
with the "+" sign facing up.
Place back the battery cover, press down slightly
and rotate it in clockwise direction until itis firmly
closed.
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1.
2.
3.
Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Use only the size and type of battery specified.
Be sure to follow the correct polarity when installing the battery as indicated in the Battery
Compartment. Areversed battery may cause damage to the device.
If the device is not to be used for a long period of time, remove the battery to prevent damage
or injury from possible battery leakage.
Do not try to recharge a battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufacturer's directions.)
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Configure Menu
Choosing the option you want from the Configure menu
1. Press the SELECT button.
(Note: if you make a mistake at any point, press the BACK button to go back to the previous
screen.)
2. Turn the knob until 'Configure' is displayed
3. Press the SELECT button.
4, Turn the knob until the display shows the option you want.
5. Press the SELECT button to choose the option shown on the display. The options are
explained below.
<Network Config>
Enables you to scan again for connection to another wireless network, or to manually
configure the network parameters. Use this if you take the Internet radio to another building
where you want to use it.
<Version>
Displays the version numbers of the various parts of software on your Internet radio.
US-10