Thermostat Installation - Hitachi airCore 700 Installation & Maintenance Manual

5.3 Thermostat Installation

[Before Installation]
(1) This packing contains the following parts.
Item
Appearance
Qty.
(2) When installing two thermostats one above the other,
allow a gap of at least 50mm between the two.
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the mounting plate, push
and turn the slotted screwdriver to separate and remove the thermostat from the mounting plate.
Groove Part
NOTE:
•
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and
the thermostat cannot be installed.
Thermostat(GC-ZKT)
1
上 上
Tabs for Attaching Controller
13
INSTALLATION & MAINTENANCE MANUAL
Screw
M4 × 16mm
2
Slotted
Screwdriver
Figure Seen from Bottom Side
mounting plate
Connecting Wire
1
more than 50mm
Approx. 6mm