Table of Contents
Advertisement
Blower
This switch controls the DC powered ventilation
blower at the starboard hull side of the bilge. The
powered ventilation system is used on gas stern
drive engines and generators. It removes any fuel
vapors via hoses installed in the lower third of the
bilge. Always run the blower for at least 4 minutes
before starting the generator. Activate blower
during generator usage.
Note to read and understand the blower warning
label on the lower right side of the switch panel.
WARNING
USB Dual Charging Port
PREVENT INJURY OR DEATH
DUE TO FIRE OR EXPLOSION!
RUN ENGINE BLOWER AT LEAST 4
MINUTES BEFORE STARTING ENGINES.
USB Charging Port
This charging port features dual USB ports (4.8
amps) and a water resistant dust cover. This
component features intelligent device recognition
for rapid charging of phones, tablets, and other
mobile devices. When not in use snap the
protective cover in place to protect the ports from
moisture and corrosion.
Panel LT
This switch controls the helm station lighting. When
you depress and hold the BRIGHT segment of the
switch the helm lighting will ramp up the brightness.
When desired light level is reached release the
switch. Depress the lower DIM segment and hold
to dim the helm lighting to a desired level.
Windshield Wiper
This switch controls the windshield wiper and
wash systems. Note the switch is "off" when the
handle is in the down position.
As the handle is moved up a series of wiper speed
positions are available. The highest speed position
is found at the top of the switch.
To operate the wash system simply press on the
wash icon on the switch while operating the wiper
and water will eject from the wiper frame on to the
glass.
Note not to run the windshield wiper over a dry
windshield as debris could cause scratching of the
tempered windshield glass.
Note that select switches may represent optional
equipment not installed on your vessel.
167
Advertisement
Table of Contents
