Craftsman CMXGLXT2700 Instruction Manual page 5

STEP 3: Attach the Beam Assembly
3.1 Remove the hitch pin (17) and R-Clip-pin (20) from the beam.
3.2 Connect the beam and the hydraulic reservoir using the large hitch pin (17)
and the R-Clip-pin (20).
20
17
STEP 4: Attach the Engine and Oil Pipe
4.1 Put the engine on the mounting plate tighten with M8x40 hex bolts (44), Ø8
flat washers (34), Ø8 lock washers (31) and M8 nylon lock nuts (77) using
two 13mm wrenches.
4.2 Attach the clear oil pipe (51) to the bottom of the gear pump and secure with
clamp (49).
51
49
5
34
44
STEP 5: Attach Hydraulic Hose
5.1 Remove the connector and the hose plugs. Both plugs may be discarded.
5.2 Attach the hydraulic hoses (6 and 15) to the filter assembly and the pump.
The Ø11x2.5 O-Ring (18) and Ø17x2.5 O-Ring (69) are preassembled in the connector.
Keep O-Rings in place during assembly.
A small amount of oil may come out of the hoses when the caps
are removed. To prevent oil dripping on the ground, use a small
pail to catch any oil.
Each connection requires only one O-Ring. Both the hose and the
fitting sides have O-Rings so remove one O-Ring before installing
the hoses. Save the extra O-Ring for possible future use/repair.
Connector
Plug
6
77
31
Hose Plug
18
69
15