Craftsman CMXGLXT2700 Instruction Manual page 3

WARNING:
Read and understand all instructions and safety information in
this manual and on safety decals before assembling or operating the log splitter.
Failure to understand and follow all instructions and safety information may result
in serious injury or death. Persons who have not read the manual should never
operate the log splitter. A log splitter can be dangerous when assembled and/or
used improperly. Do not operate the log splitter if you have any questions
concerning safe operation. Please call the technical support department at
1-888-331-4569 for answers to any questions.
WARNING:
This product can expose you to chemicals including lead and
lead compounds which are known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information, go to
www.P65Warnings.ca.gov
WARNING:
NEVER use the log splitter for any purposes other than splitting
wood. The log splitter is designed only for splitting wood. Using the log splitter for
any other purpose can result in serious injury or death and may void the warranty.
WARNING: IMPORTANT SAFETY INFORMATION
1) GENERAL SAFETY
• ALWAYS keep the operator's manual in the canister for reference. Review the manual
periodically and as questions arise.
• ALWAYS keep all bystanders and pets a minimum of 10 feet away from your work area
when operating this log splitter. The operator alone should be near the log splitter during
use.
• NEVER activate the control valve until all people are clear of the work area.
• NEVER wear loose clothing or jewelry when operating the log splitter. Keep clothing and
hair away from all moving parts when operating the log splitter.
• NEVER allow adults without proper instruction and operational knowledge to use the log
splitter.
• NEVER operate the log splitter when under the influence of drugs, alcohol or medication
or when otherwise not alert enough to operate the log splitter.
• DO NOT allow children to play on, stand upon, climb on or operate the log splitter at any
time
2) WORK AREA
• NEVER operate the log splitter on wet, icy, slippery or unstable ground.
• NEVER operate the log splitter in an enclosed area. Exhaust fumes contain carbon
monoxide which is deadly poison.
• ONLY operate the log splitter with adequate lighting.
• ONLY operate the log splitter on level ground. Operating on a slope may cause the log
splitter to move and/or logs to fall off the log splitter.
• ALWAYS keep the work area free of debris. Remove any split wood around the log
splitter immediately to avoid tripping.
3) PREPARING LOGS FOR THE SPLITTER
Log ends should be cut as squarely as possible before placing logs on the log splitter.
The square shape of the log helps prevent the logs from moving during splitter operation.
The maximum log length is 26 inches.
4) OPERATION OF THE LOG SPLITTER
ONLY operate the log splitter from the operator zone as shown in the diagram.
Operating the log splitter outside the operator zone can result in serious injury or death.
• ALWAYS chock the wheels to prevent movement of the log splitter while in operation.
• ALWAYS check and tighten hardware and assembled parts before operation.
• DO NOT operate the log splitter at night, only during daylight hours.
• KNOW how to stop the log splitter and disengage the controls before operating it.
• NEVER try to split a log against the grain.
• NEVER try to split two logs at the same time.
• NEVER step over the log splitter during operation.
• NEVER reach or bend over the log splitter to pick up a log.
• NEVER attempt to load the log splitter when the wedge is in motion.
• NEVER place hands or feet between the log and splitting wedge during forward or
reverse stroke as this could result in serious injury or death.
• NEVER use your foot, a rope or any extension device to operate the control lever on
the valve. Only use hands to operate control levers.
• NEVER touch the muffler and other hot areas of the engine. Allow time for the engine
to cool down before touching.
3
• NEVER move the log splitter while the engine is running. Turn off the engine before
leaving the log splitter.
• NEVER leave the log splitter running unattended, even for a short period of time.
OPERATOR
ZONE
HORIZONTAL POSITION
VERTICAL POSITION
5) GENERAL REPAIR
• NEVER operate the log splitter if it is in poor mechanical condition or in need of repairs.
• NEVER alter/modify the log splitter in any way. Any alterations/modifications may make
the log splitter unsafe and voids the warranty.
• NEVER perform any service or repair on the log splitter without first removing the spark
plug wire.
• NEVER tamper with the engine settings. The maximum engine speed is preset by the
manufacturer and is within safety limits. Refer to the engine's user manual for the
particular log splitter.
• ALWAYS perform all recommended maintenance procedures before using the log splitter.
• ALWAYS check the level of hydraulic oil and engine oil before operating the log splitter.
• NEVER use hands to remove a stuck log while the log splitter is running.
• ALWAYS replace all damaged or worn parts immediately.
• ALWAYS check regularly that all nuts, bolts, screws, hydraulic fittings and hose clamps
are tight.
• ALWAYS be sure any and all replacement parts meet the manufacturer's specifications.
6) MAINTENANCE AND STORAGE
• The mechanical and hydraulic systems of the log splitter require careful inspection. Be
sure to replace damaged hydraulic hoses and components.
• NEVER check for leaks of hydraulic fluid by using your hands. Leaking hydraulic fluid under
pressure can potentially penetrate the skin causing SERIOUS INJURY or even DEATH.
Leaks can be safely detected by holding a piece of cardboard over the suspected leak and
looking for discoloration.
• NEVER remove the cap from the hydraulic tank while the log splitter is running. The tank
contains hot oil under pressure which could cause serious injury if released from the tank.
• NEVER adjust the relief valve setting. The pressure relief valve on the log splitter is preset
at the factory. Only a qualified service technician should perform any adjustments.
• ALWAYS immediately seek medical attention if injured by escaping hydraulic fluid. Serious
infections or reactions can develop if proper medical treatment is not administered
immediately.
• ALWAYS check the system is not under any pressure by shutting off the engine and
moving the valve control handle back and forth. Check for pressure before loosening or
removing any hydraulic fitting.
• ALWAYS keep the beam and wedge free of debris buildup.
• Before storing make sure the log splitter is clean and dry for years of trouble-free service.
• Lightly lubricate all log splitter surfaces and moving parts to prevent rust.
• Store indoors or protected area during severe weather and winter months.
ENGINE
BEAM
ENGINE
TOW BAR
ASSEMBLY