Changing The Programme After It Has Started; Cancelling The Programme; Programme End - Blomberg LTP 2832W User Manual

Operating the product
6.11 Changing the programme
after it is started
After the machine starts running, you can
change the programme you selected to dry
your laundry with a different programme.
1. For example, to select Extra Dry
programme instead of the Iron Dryness,
stop the programme by pressing the Start
/ Pause button.
2. Turn the Programme Selection knob to
select the Extra Dry programme.
3. Start the programme by pressing the Start
/ Pause button.
Adding and removing laundry in
stand-by mode
If you want to add or remove laundry after the
drying programme starts:
1. Press the Start/Pause button to take the
machine into Stand-by mode. Drying
operation stops.
2. Open the loading door, add or remove
laundry and close the loading door.
3. Start the programme by pressing the Start
/ Pause button.
C
The laundry adding made after
the drying operation started may
cause the dried laundry inside
the machine to mix with the wet
laundry and the laundry to remain
damp after the operation ends..
C
Laundry adding and removing can
be repeated as much as desired
during drying operation.
But this process would
continuously interrupt the drying
operation, and so would cause the
programme duration to lengthen
and increase energy consumption.
Thus, it is recommended to add
laundry before the programme
starts.
C
If a new programme is selected
by changing the position of the
programme selection knob while
your machine is in stand-by mode,
the running programme ends.
Dryer / User Manual
Do not contact the inner surface
of the drum when adding or
removing laundry during a
continuing programme. The drum
surface is hot.

6.12 Cancelling the programme

If you want to cancel the programme and
end the drying operation for any reason after
the machine starts running, press the On/Off
button.
A
As it will be extremely hot inside
the machine when you cancel the
programme while the machine is
in operation; run the ventilation
programme to cool it down.

6.13 Programme end

When the programme ends, the Final/Wrinkle
Prevention, Fiber Filter Cleaning and Water
Tank Warning leds on the programme follow
up indicator light up. Loading door can be
opened and machine becomes ready for a
second run.
Press the On/Off button to turn off the
machine.
C
In case the laundry is not removed
after the programme is completed,
the wrinkle prevention program
that lasts 2 hours start in order to
prevent wrinkling of the laundry
that remains inside the machine.
C
Clean the fiber filter after each
drying. (See. „Fiber filter and
loading door inner surface")
C
Empty the water tank after each
drying. (See. „Emptying the water
tank")
25 / EN