Guardian AC9600W - GermGuardian Large Room Air Purifier with UV-C, 360-Degree HEPA & Air Quality Monitor Manual

SPECIFICATIONS

Air Purifying System with HEPA Filter

CONTROL PANEL

AIR CLEANING SYSTEM

Improve your indoor air quality with your new Germguardian Air Purifier. The HEPA filter captures allergens and includes a charcoal filter layer to help reduce household odors. The UV-C light technology helps reduce germs and works with Titanium Dioxide (TiO2) to reduce volatile organic compounds.

The air purifier is shipped with the filter stored in the filter compartment.
The filter is shipped in a bag to prevent degradation. Before using, remove and discard bag.

OPERATING INSTRUCTIONS

The air purifier is shipped with the filter stored in the filter compartment.
The filter is shipped in a bag to prevent degradation. Before using, remove and discard bag.

BEFORE OPERATING THE DEVICE

1. Select a firm, level and flat location for the air purifier.
   • For proper air flow, locate the unit at least 1 foot from any wall or furniture.
   • Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet. An audible chime will sound when plugged in.

OPERATING THE DEVICE

	Turn unit power ON by pressing the ON/OFF button. Note: The first time the unit is plugged in and powered on, the air quality sensor will take a few minutes to calibrate.
	Fan Speed – press SPEED and select speed level 1-4. The fan speed will light on the display.
	Auto Mode – press AUTO and an "A" will light on the display. When in AUTO the fan speed will change depending on the air quality level in the room. See AQM chart. To exit AUTO mode, press AUTO control. Pressing on/off, speed or sleep controls will also exit AUTO mode.
	Sleep Mode – Press Sleep control to turn display lights on/off. When selected, all but the sleep light will turn off and purifier will run in low speed. Press any control to wake up the unit and exit Sleep mode.
	UV Mode – To activate the UV-C Bulb, press the UV button. Press the button again to turn OFF the UV-C. The light on the top of the UV button will turn on when the UV-C is on.
	Child Lock – Press and hold SPEED & AUTO controls for 3 seconds to lock control panel so controls cannot be adjusted. The lock icon will light on the display. If other controls are pressed while locked, the Child Lock indicator will blink. To unlock, hold the SPEED & AUTO controls again for 3 seconds.
	Filter Reset Indicator illuminates to indicate it is time to change the filter. Replace the filter according to the instructions. Press and hold the SPEED button for approximately 3 seconds, the unit will beep before flashing indicator stops.

AIR QUALITY MONITOR

Air Quality Monitor senses and detects the amount of particulate matter (PM2.5) in the air.
The bar above the display will change colors, indicating the air quality level in the room.
The particulate matter numeric value (AQI) will be displayed. See values and status ranges in chart below.
Also listed are the color values displayed on the indicator light and the fan speed "AUTO" mode will select based on the particulate matter that is detected.

RESETTING THE DEVICE

The air purifier is equipped with a motor protection circuit. If activated, the overload warning will initiate and cut off the power. An audible warning "chime" will sound for 60 seconds and the AQM light will flash red. To restart the unit, unplug the unit for 10 minutes, then plug back in and power on.

FILTER REPLACEMENT

The filter reset indicator light will illuminate when it is time to replace your filter. Depending on usage and environmental conditions the filter will last approximately 6 months. The inside pleats of the filter will turn from white to grey when it is dirty and needs replacing. It is important to maintain and change the filter to continue to optimize the performance of the air purifier.

Do NOT wash and re-use the filter. Please contact Customer Service or visit our website www.guardiantechnologies.com to purchase a replacement filter. Use only Genuine Guardian Technologies replacement parts to optimize the performance of your air purifier.

REMOVE AND REPLACE FILTER

1. Turn off and unplug the unit.
2. On the back of the unit, pull handle on filter panel and remove panel from unit.
   
3. Remove filter and disregard. Place new filter into air purifying unit.
   
4. Return filter panel, first insert the panel tabs in the base then close. Check that it's secure.
5. Reset the filter light by holding the Speed controls down for 3 seconds.

Make sure filter is installed and back panel is closed properly, otherwise unit will not function.

INSTALLING & REMOVING UV-C BULB

CHANGE BULB INDICATOR
The white light above the UV indicator will begin to flash continuously when it is time to replace the UV-C bulb. Replace the bulb according to the directions then press the UV control button and hold for 3 seconds to restart the system.

1. The UV-C bulb is in a compartment above the filter in the purifier.
2. To access, first follow the instructions to remove the filter.
3. Turn the purifier on its side for easier access to the compartment.
4. Reach inside to detach the UV-C grate. Use a Philips head screwdriver to remove the four (4) screws. Detach the grate.
   
5. The UV-C Bulb is removed by carefully grasping the bulb with a clean cloth or tissue, twisting it 90 degrees and pulling the bulb straight out of the unit.
   
6. The UV-C Bulb is reinstalled by sliding it, horizontally, back into the slots at the top of the unit. Twist 90 degrees to lock into place.
7. Press and hold the UV Control Button for 3 seconds to reset UV Bulb Change Indicator.

The UV-C bulb should be replaced every 10 months depending on use.

If the filter is not placed in properly or the filter cover is not secure, the unit will not turn on.

CLEANING & MAINTENANCE

CLEANING

• Always unplug the appliance before you clean it.
• Never immerse the appliance in water or any other liquid.
• Never use aggressive or flammable cleaning agents such as bleach or alcohol to clean any part of the appliance.

BODY OF THE APPLIANCE

Regularly clean the inside and outside of the body to prevent dust from collecting.

1. Wipe away dust with a soft dry cloth from the body of the appliance.
2. Clean the air inlet and the air outlet with a soft dry cloth.

PRE-FILTER SCREEN

The pre-filter/charcoal layer collects larger dust and debris and should be cleaned monthly or more frequently depending on use. Remove and clean regularly with the brush attachment of your vacuum cleaner. This will remove the lint and dirt and help maintain the life of the filter.
(See filter replacement to locate and clean or remove the filter).

REPLACEMENT PARTS

FILTER:
Model No.
FLT9400

UV BULB:
Model No.
LB9000

Check out our
AutoShip&Save
Filter Replacement Program
www.guardiantechnologies.com

To maintain performance of the air cleaner, use Guardian Technologies GENUINE Replacement Parts only.
To purchase visit our website www.guardiantechnologies.com.

Note: Do NOT stick any foreign objects or your fingers inside the unit.

What is CADR?
CADR stands for "Clean Air Delivery Rate," which indicates the volume of filtered air delivered by an air purifier. CADR ratings show the effectiveness of how efficient the air purifier is at capturing fine particles from things like tobacco smoke and plant pollens from the room.

Clean Air Delivery Rate
From air cleaner to air cleaner, compare the CADR numbers. First look at suggested room size. Then refer to the Clean Air Delivery Rate (CADR) numbers. The higher the number, the faster the unit filters the air.
Refer to website for individual model CADR numbers.

TROUBLESHOOTING GUIDE

WARNINGS

Failure to comply with the warnings listed below may result in electric shock or serious injury.

This product should be used only in accordance with the specifications outlined in this manual. Usage other than what has been specified here may result in serious injury.

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:

• Read all instructions before using appliance.
• 
  To reduce the risk of fire or electric shock do not use with an extension cord.
• 
  To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet.
• 
  Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, near heat registers, radiator, stoves or heaters.
• 
  To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.
• Extreme caution is necessary when any appliance is used by or near children or people with disabilities and whenever the appliance is left operating unattended.
• Always unplug the air purifier before moving it, opening the grill, changing filters, cleaning or whenever the air purifier is not in use. Be sure to pull by the plug and not the cord.
• NEVER drop or insert any object into any openings.
• DO NOT run cord under carpeting.
• DO NOT cover cord with throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Call Customer Service for assistance.
• 
  Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
• DO NOT use outdoors.
• DO NOT place anything on top of unit.
• NEVER block the air openings, grills/outlets or place on a soft surface such as a bed or sofa, as this could cause the unit to tip over, blocking the air intake or outtake opening.
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
  Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
• 
  To reduce the risk of fire or electric shock, do not use this purifier with any solid-state speed control device.
• 
  This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualifed electrician. Do not attempt to defeat this safety feature.
• 
  Skin or eye damage may result from directly viewing the light produced by the lamp in this apparatus. Always disconnect power before replacing lamp or servicing. Replace with Lamp Model No. LB9000, Manufactured by Guardian Technologies.
• Always unplug the unit before cleaning or servicing in any way.
• 
  Do NOT use gasoline, benzene, thinner, harsh cleaners, etc. on and/or in the unit while cleaning as they will damage the product. NEVER use alcohol or other solvents.

THIS EQUIPMENT SHOULD BE INSPECTED AND CLEANED IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS ON A REGULAR BASIS TO PREVENT EXCESSIVE ACCUMULATION OF DUST PARTICLES THAT CAN RESULT IN FLASHOVER OR A RISK OF FIRE.

The 8 hour TWA Ozone for this product is 0.001 ppmv when tested in a 30 m³ chamber. The product complies with the maximum allowable concentration of ozone of 0.050 parts per million by volume (ppmv) in a 24-hour period. The Health Canada Guideline 2010 recommends that the maximum exposure limit, based on averaging time of 8 hours, is 0.020 ppmv or less when tested in a sealed, controlled room approximately 30 m³.

Cancer and Reproductive Harm.
For more information go to www.P65Warnings.ca.gov.

LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup Requirements. In case of breakage, follow clean-up procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010

The use of this device is a supplement to and not a substitute for standard infection control practices; users must continue to follow all current infection control practices, including those practices related to cleaning and disinfection of environmental surfaces.

LIMITED WARRANTY

Address returns to the attention of: Repair Department, at the address below. Additional questions or comments can be made toll free to the number listed below.
USA and Canada
Guardian Technologies LLC
26251 Bluestone Blvd.
Euclid, Ohio 44132
1.866.603.5900
www.guardiantechnologies.com

Please go to www.guardiantechnologies.com to register your product. We consider the registration process important to ensuring superior service to our customers, however submitting the registration is optional and does not affect your rights to utilize this warranty according to the conditions stated above.

Additional copies of the instruction manual can be obtained by accessing and printing directly from our website or calling customer service.

Documents / Resources

References

• Lasko, GermGuardian, B-Air, BlueDri | Fans, Heaters, Air Purifiers – GuardianTechnologies
• http://www.p65warnings.ca.gov
• Cleaning Up a Broken CFL | US EPA

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Guardian AC9600W - GermGuardian Large Room Air Purifier with UV-C, 360-Degree HEPA & Air Quality Monitor Manual