Segway Ninebot ES1,ES2,ES4, ES Series - KickScooter Manual

Introduction

Thanks for choosing the Ninebot KickScooter ES series!
Thanks for choosing the Ninebot KickScooter (hereinafter referred to as KickScooter)!
Your KickScooter is a fashionable transportation device with mobile app, allowing you to connect with other riders.
Enjoy your ride and connect with riders world wide!

Always use both electric brake and foot brake for emergency stopping. Otherwise you risk falls and/or collisions from not achieving the max. braking capability.

Packing List

Second Battery Pack

	ES1	ES2	ES4
	Sold separately		Included

Accessories

When unboxing your KickScooter, please verify that the above items are included in the package. If you are missing any components, please contact your dealer/distributor or nearest service center (see contacts in the user manual). After verifying that all components are present and in good condition, you can assemble your new KickScooter.
Please retain the box and packaging materials in case you need to ship your KickScooter in the future.
Remember to power off your KickScooter and unplug the charge cable before assembling, mounting accessories, or cleaning the mainframe.

Diagram

Dashboard & Power Button

Speedometer: Indicates the current speed. Also displays error codes when faults are detected.
Power level: Indicates the remaining battery level with 5 bars. Each bar equates to approximately 20% power level.
Power mode (double click the power button to switch the mode):

• Red "S" icon: Sport mode (maximum power/speed and reduced range).
• White "S" icon: Standard mode (moderate power/speed and range).
• No "S" icon: Speed limit mode (minimum power/speed and increased range).

Bluetooth: A blinking Bluetooth icon indicates that the vehicle is ready to connect. A solid Bluetooth icon indicates that the vehicle is connected to a mobile device.
Power button: Short press to power on. Long press to power off. When powered on, single click to turn on/off the headlight. Double-click to change power mode.

Assembling Your KickScooter

1. Unfold the stem and push it until you hear a click. Then unfold the kickstand to support the scooter.
   
2. Firmly connect the wires inside the handle and the stem. Slide the handle onto the stem. Be aware of the correct orientation.
   
3. Install four screws (two on each side) with the included hex wrench.
   
4. Verify that your KickScooter powers on and off.
   

Installing a Second Battery Pack

Follow these steps when installing a second battery pack:

1. Remove the three screws on the stem, as shown. Then remove the cover near the charge port.
   
2. Install the support bracket and fasten securely with three screws, as shown.
   
3. Install the battery pack onto the support bracket and tighten the screws securely.
   
4. Verify that your KickScooter powers on and off.
   

First Ride

There are safety risks when learning to ride the KickScooter. You must read the Safety Instructions via the App before your first ride.
For your safety, your new KickScooter is not activated and will beep occasionally after Power ON.
Until activated, the KickScooter maintains a very low riding speed, and can not be ridden with full function. Install the App on your mobile device (with Bluetooth 4.0 or above), connect to the KickScooter with Bluetooth, and follow the App instructions to activate your KickScooter and enjoy the full performance.
Scan the QR code to download the App (iOS 8.0 or above, Android™ 4.3 or above).

1. Install the App and register/login.
   
2. Power on the KickScooter. A blinking Bluetooth icon indicates the KickScooter is waiting for a connection.
   
3. Click "Vehicle"→"Search device" to connect to your KickScooter.
   The KickScooter will beep when the connection is successful. The Bluetooth icon will stop blinking and remain illuminated.
   
4. Follow the App instructions to active the KickScooter and learn how to ride safely.
   You can now start to use your KickScooter, check the status with App, and interact with other users. Have fun!

Charging

Charging step tips

• Open the charge port cover.
  
• Insert the charge plug.
  
• Close the charge port cover when finished.
  

Do not connect the charger if the charge port or charge cable is wet.
Your KickScooter is fully charged when the LED on the charger changes from red (charging) to green (trickle charge). Close the charge port cover when not charging.

Learning to Ride

Wear an approved helmet and other protective gear to minimize any possible injury.

1. Power on the scooter and check the indicator lamp power level. Charge the scooter if the battery level is low.
   
2. Stand on the footrest with one foot and push off with your foot to start gliding.
   
3. Put your other foot on the footrest to keep both feet stable. Press the throttle on right hand to speed up when you are balanced.
   
   Note: For your safety, the motor will not engage until the scooter reachs 1.8 mph (3 km/h).
4. Slow down by releasing the throttle; stir the brake handle thumb shifter quickly and stamp the fender with foot at the same time to trigger mechanical braking in order to make a sharp brake.
   
5. To turn, shift your body weight and turn the handle slightly.
   

When braking rapidly you risk serious injury due to loss of traction and falls. Maintain a moderate speed and look out for potential hazards.

Warnings

Failure to follow these instructions could lead to serious injury.

• DO NOT ride the scooter in the rain.
  
• DO NOT ride over speed bumps, thresholds, or other bumps at HIGH SPEED.
  
• Watch your head when passing through doorways.
  
• Watch your speed when traveling downhill. Use both brakes together when traveling at high speed.
  
• DO NOT press the throttle when walking with the scooter.
  
• Avoid contacting obstacles with the tire/wheel.
  
• DO NOT carry heavy objects on the handlebar.
  
• DO NOT ride the scooter with only one foot.
  
• DO NOT ride on public roads, motorways, or highways.
  
• DO NOT rotate the handle violently while driving at high speed.
  
• DO NOT ride through puddles or. other bodies of water deeper than 1 inch (2 cm).
  
• The KickScooter is for one rider only. Do not ride double or carry any passengers. Do not carry a child.
  
• DO NOT step on the folding pedal while riding.
  
• DO NOT touch the hub motor after riding because it can get hot.
  
• DO NOT take your hands off the handlebar while riding. Do not ride with one hand only.
  
• DO NOT ride up and down stairs or jump over obstacles.
  

Always keep both hands on the handlebar or you risk serious injury due to loss of balance and falls.

Folding and Carrying

Folding

Step on the folding pedal while pushing the handlebar forward slightly. Then fold the handlebar down until it locks into the rear fender.

Carrying

When your KickScooter is folded up, simply lift it by the stem to carry.

Maintenance

Cleaning and Storage

Use a soft, wet cloth to wipe the mainframe clean. Hard to remove dirt can be scrubbed with a toothbrush and toothpaste, then cleaned with a soft, wet cloth. Scratches on plastic parts can be polished with fine grit abrasive paper.

NOTE
Do not wash your KickScooter with alcohol, gasoline, acetone, or other corrosive/volatile solvents. These substances may damage the appearance and internal structure of your KickScooter. Do not wash your KickScooter with a power washer or hose.

Make sure the KickScooter is powered OFF, the charging cable is unplugged, and the rubber cap on the charge port is tightly sealed before cleaning; otherwise you may damage the electronic components.
Store your KickScooter in a cool, dry place. Do not store it outdoors for extended periods of time. Exposure to sunlight and temperature extremes (both hot and cold) will accelerate the aging process of the plastic components and may reduce battery life.

Battery Pack Maintenance

Do not store or charge the battery at temperatures outside the stated limits (see Specifications). Do not puncture the battery. Refer to your local laws and regulations regarding battery recycling and/or disposal.
A well maintained battery can perform well even after many miles of riding. Charge the battery after each ride and avoid draining the battery completely. When used at room temperature (70°F [22°C]) the battery range and performance is at its best; whereas using it at temperatures below 32°F (0°C) can decrease range and performance. Typically, at -4°F (-20°C) range can be half that of the same battery at 70°F (22°C). Battery range will recover when temperature rises. More details are available in the App.

NOTE
Typically, a fully charged battery should retain charge for 120-180 days in Standby Mode. A low-power battery should retain charge for 30-60 days in Standby Mode. Remember to charge the battery after each use. Completely draining the battery may cause permanent damage to the battery. Electronics inside the battery record the charge-discharge condition of the battery; damage caused by over-discharge or under-discharge will not be covered by the Limited Warranty.

Do not attempt to disassemble the battery. Risk of fire. No user serviceable parts.

Do not ride when the ambient temperature is outside the machine operation temperature (see Specifications) because low/high temperature will limit the maximum power/torque. Doing so could cause personal injury or property damage due to slips or falls.

Specifications

1. Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement.
2. All KickScooter models could install the second battery. Some of the parameters would change in this case.

Riding Safety

1. The KickScooter is a recreational transporter. Before mastering riding skills, you need to practice. Neither Ninebot Inc. (means Ninebot (Beijing) Tech Co., Ltd.and its subsidiaries and affiliates) nor Segway Inc. is responsible for any injuries or damage caused by a rider's inexperience or failure to follow the instructions in this document.
2. Please understand that you can reduce the risk by following all the instructions and warnings in this manual, but you cannot eliminate all the risks. Remember that whenever you ride the KickScooter you risk injury from loss of control, collisions, and falls. When entering into public spaces always comply with the local laws and regulations. As with other vehicles, faster speeds require longer braking distance. Sudden braking on low traction surfaces could lead to wheel slip, or falls. Be cautious and always keep a safe distance between you and other people or vehicles when riding. Be alert and slow down when entering unfamiliar areas.
3. Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that fits properly with the chin strap in place, and provides protection for the back of your head.
4. Do not attempt your first ride in any area where you might encounter children, pedestrians, pets, vehicles, bicycles, or other obstacles and potential hazards.
5. Respect pedestrians by always yielding the right of way. Pass on the left whenever possible. When approaching a pedestrian from the front, stay to the right and slow down. Avoid startling pedestrians. When approaching from behind, announce yourself and slow down to walking speed when passing. Please obey local traffic laws and regulations if situation is different.
6. In places without laws comply with the safety guidelines outlined in this manual. Neither Ninebot Inc. nor Segway Inc. is responsible for any property damage, personal injury/death, accidents, or legal disputes caused by violations of the safety instructions.
7. Do not allow anyone to ride your KickScooter on his/her own unless they have carefully read this manual and followed the New Rider Tutorial in the App. The safety of new riders is your responsibility. Assist new riders until they are comfortable with the basic operation of the KickScooter. Make sure each new rider wears a helmet and other protective gear.
8. Before each ride check for loose fasteners and damaged components. If the KickScooter makes abnormal sounds or signals an alarm, immediately stop riding. Diagnose your KickScooter via the Ninebot by Segway App and call your dealer/distributor for service.
9. Be alert! Scan both far ahead and in front of your KickScooter — your eyes are your best tool for safely avoiding obstacles and low traction surfaces (including, but not limited to, wet ground, loose sand, loose gravel, and ice).
10. To reduce risk of injury, you must read and follow all "CAUTION" and "WARNING" notices in this document. Do not ride at an unsafe speed. Under no circumstance should you ride on roads with motor vehicles. The manufacturer recommends riders be 14+ years old. Always follow these safety instructions:
    1. People who should not ride the KickScooter include:
       1. Anyone under the influence of alcohol or drugs.
       2. Anyone who suffers from disease that puts them at risk if they engage in strenuous physical activity.
       3. Anyone who has problems with balance or with motor skills that would interfere with their ability to maintain balance.
       4. Anyone whose weight is outside the stated limits (see Specifications).
       5. Pregnant women.
    2. Riders under the age of 18 years old should ride under adult supervision.
    3. Comply with local laws and regulations when riding this product. Do not ride where prohibited by local laws.
    4. To ride safely, you must be able to clearly see what is in front of you and you must be clearly visible to others.
    5. Do not ride in the snow, in the rain, or on roads which are wet, muddy, icy, or that are slippery for any reason. Do not ride over obstacles (sand, loose gravel, or sticks). Doing so could result in a loss of balance or traction and could cause a fall.
11. Do not attempt to charge your KickScooter if it, the charger, or the power outlet is wet.
12. As with any electronic device, use a surge protector when charging to help protect your KickScooter from damage due to power surges and voltage spikes. Only use the Segway supplied charger. Do not use a charger from any other different product models.
13. Use only Ninebot or Segway approved parts and accessories. Do not modify your KickScooter. Modifications to your KickScooter could interfere with the operation of the KickScooter, could result in serious injury and/or damage, and could void the Limited Warranty.

Contact

Contact us if you experience issues relating to riding, maintenance and safety, or errors/faults with your KickScooter.

Americas:
Segway Inc.
14 Technology Drive, Bedford, NH 03110, USA
Tel: 1-603-222-6000
Fax: 1-603-222-6001
Toll Free: 1-866-473-4929
E-mail Sales: customeroperation@segway.com
E-mail Service: technicalsupport@segway.com
Website: www.segway.com

Europe, Middle East and Africa:
Segway Europe B.V.
Hogehilweg 8, 1101CC Amsterdam, The Netherlands
Email service: service@segway.eu.com
Website: www.segway.com

Have your KickScooter serial number on hand when contacting Segway.
You can find your serial number on the underside of your KickScooter or in the App under More Settings –> Basic Information.