Table of Contents
Advertisement
LUBRICATION GUIDE
1. Engine filler cap and dipstick
2. Steering knuckles (2)
(Both sides)
3. Front axle pivot bolt
(Right side)
—Before Each Use
Check the oil (with the engine stopped) and add sufficient new oil to
bring it to the "FULL" mark on the dipstick. Do not overfill. Do not
operate the engine if the oil level is below the "LOW" mark on the
dipstick.
—After Every 10 Hours of Operation
Use 251H EP grease or equivalent No. 2 multi-purpose lithium
grease and apply sufficient grease to flush out old grease and dirt.
Use 251H EP grease or equivalent No. 2 multi-purpose lithium
grease and apply sufficient grease to flush out old grease and dirt.
NOTE:
It may be necessary to rotate the front axle to reach the
grease fitting.
4. Drive shaft bushing
5. Front wheel bearings
—After Every 30 Hours of Operation
Two or three strokes of the lubricator using 251H EP grease or
equivalent No. 2 multi-purpose lithium grease.
Two or three strokes minimum of the lubricator using 251H EP
grease or equivalent No. 2 multi-purpose lithium grease.
6. Engine oil drain plug and oil
filter
Transmission
7. Oil level and filler plug
8. Oil drain plug
Creeper drive housing
9. Level plug
10. Breather and filler plug
11. Drain plug
12. Steering gear housing
Miscellaneous
Brake pedal shaft
Alignment couplings
—After Every 50 Hours of Operation
While the engine oil is warm, remove the drain plug and oil filter (5),
and drain all of the oil from the crankcase and oil filter lines. Replace
the drain plug.
Refer to "MAINTENANCE," "FILLING THE
CRANKCASE" & "OIL FILTER" for proper oil filling procedure.
Refer to "LUBRICATION TABLE" for the proper quantity and viscos¬
ity to use.
—After Every 100 Hours of Operation
Check the oil level at the beginning and end of each season. Keep
the lubricant up to "FULL" on dipstick.
Check the oil level at the beginning and end of each season.
Every 100 hours of yearly use 251H EP grease or equivalent No. 2
multi-purpose lithium grease. Apply two strokes with lubricator.
Lubricate the brake pedal shaft and linkage with eight or ten drops of
engine oil.
Use 251H EP grease or equivalent No. 2 multi-purpose lithium
grease.
NOTE
Lubrication information for optional equipment may be found in the manual which is included with the
specific piece of optional equipment.
37
Advertisement
Table of Contents
