Lubrication Table - Cub Cadet 1535 Owner's Manual

LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Antici sated Air Temper* ature
Above +32°F +32°F to 0°F Below 0°F
Engine crankcase Check
before
each
use
50 3 pints
8 ounces
(1-3/4 quarts)
Cub Cadet
Low Ash
Engine Oil
SAE 30
Cub Cadet
Low Ash Oil
SAE 10W-40
or 10W-30
Cub Cadet
Low Ash
Engine Oil
SAE 5W-20
or 5W-30
Steering knuckles &
front axle pivot bolt
10
Use 251H EP grease or equivalent No. 2 multi¬
purpose lithium grease and apply two or three
strokes or sufficient grease to flush out old
grease and dirt.
Front wheel bearings 30
Two or three strokes minimum of the
lubricator using 251H EP grease or equivalent
No. 2 multi-purpose lithium grease.
Steering gear housing 100 or
yearly
1/4 lb
Two strokes of the lubricator using
251H EP grease or equivalent No. 2 multi¬
purpose lithium grease.
Transmission
100
Add
as needed
8
pints
approx.
Cub Cadet
Hydraulic Transmission Fluid
NOTE:
Cub Cadet
hydraulic transmission
fluid meets IH B-6 specifications. If fluid is
used that does not meet these requirements
Cub Cadet
will not be responsible for
substandard performance. Failures due to
use of improper fluid are not covered by
warranty. For maximum protection, use
Cub Cadet
Hydraulic Transmission Fluid.
Creeper drive housing
100 Add
as needed
10 ounces
SAE 85W-140W Gear Lube
Drive shaft lubricating
bushing
30 or
as needed
Two or three strokes of the lubricator
using 251H EP grease or equivalent No. 2
multipurpose lithium grease.
Alignment couplings
251H EP grease or equivalent No. 2 multi¬
purpose lithium grease.
35