Page 2
Continuous blending for any electrical appliance. (e.g., soda, baking more than one minute If you let anyone else use your nutribullet Portable Blender, ensure ® powder, baking soda, may cause the Cup they understand the health and safety information in this User...
Page 3
- Allow the Cup to cool resulting in damage bulletbrands.com.au / parts may damage your for at least 30 minutes. to the unit or injury. bulletbrands.co.nz nutribullet Portable ® If still warm, allow for Always make sure the or by contacting Blender or create safety more cooling time.
Page 4
PRODUCT SAFETY • Do not remove the • Do not expose your Blades are sharp! Cup or Lid until the nutribullet Portable ® Handle with care to blades have completely Blender to extreme Discontinue use if avoid bodily injury. stopped. Blades can...
Page 5
® DISHWASHER. Blender components bulletbrands.co.nz. • Disconnect the USB for damage or wear cable from the USB • Use only nutribullet ® that may impair proper port and the motor attachments/ Modification, improper functioning or create a base once the portable...
Page 6
BATTERIES waste. Lithium-Ion pull on them as they a damaged cable or move around or walk batteries in compacting • Your nutribullet appliance malfunction, ® through the area. rubbish trucks pose a Portable Blender or if or if the Motor risk of ignition.
Page 7
• Recommended storage and ambient charging temperature: 10°C−40°C. • Do not use your unit in any area with a potentially explosive atmosphere (e.g., fueling areas or fuel service stations, below decks on boats or other vessels, fuel and/or chemical transfer and storage facilities, and areas where flammable chemicals or particles,...
Contents. What’s included Assembly guide LED light indicator status Charging Settings Errors Using the nutribullet ® Portable Blender Care and maintenance Replacement parts One-year limited warranty Thank you for purchasing the nutribullet Portable Blender. ®...
590ml cup to-go lid charging cable 20oz cup USB-C charging Cable Spout lid with handle 590ml cup Product configurations may vary. To see our full list of nutribullet accessories ® please visit bulletbrands.com.au / bulletbrands.co.nz. measurement markings Before fi rst use.
LED light indicator status. The nutribullet Portable Blender’s ® indicator has six LED light bars that appear red or blue according to the unit’s operational status. See below for details. Charging. Settings. No power Wake All LEDs off. Press button once to wake up your blender.
Overheat NEVER run the nutribullet ® Light ring will turn red. Fully charge your blender Portable Blender for more than before first use. The charging one minute at a time, as it can Solution: Pause activity and allow port is located under the light cause permanent damage to blender to cool before next use.
Using the nutribullet ® Portable Blender. Wake up your blender by Once your blender is Direction #5 Direction #6 pressing the Power button awake, press the Power once. Wait about 1 second button again to start a for the light animation 20-second blend cycle.
STEP 4: STEP 1: Always store your nutribullet Always make sure the nutribullet ® ® Portable Blender in a safe Portable Blender is turned off place, upright with the Cup after each use. attached, so that the blades are STEP 2: covered and not exposed.
Page 15
2A 10W Capital Brands Distribution, LLC | All rights reserved. nutribullet Portable Blender is the trademark of CapBran Holdings, LLC ® registered in the U.S.A. and worldwide. Illustrations may differ from the actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.
Need help?
Do you have a question about the Portable Blender and is the answer not in the manual?
Questions and answers