Advertisement
Quick Links
LED Work Light Kit
RT1200 Trencher
Model No. 144-2581
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
LED work light
Adapter plate
Screw (M6 x 55)
Screw (#10 x 1/2 inch)
Locknut (#10)
U-nut (#10)
© 2022—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Qty.
–
Remove the work lights.
4
4
8
Install the LED work lights.
16
16
8
Register at www.Toro.com.
Form No. 3454-733 Rev A
Installation Instructions
Use
*3454-733*
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Advertisement
Summary of Contents for Toro 144-2581
- Page 1 Form No. 3454-733 Rev A LED Work Light Kit RT1200 Trencher Model No. 144-2581 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Remove the work lights.
- Page 2 Preparing the Machine Disconnect the 2-pin connector from the 2-socket connector, and remove the 2 rear work Park the machine on a level surface and engage lights from the rear lighting mount plate. the parking brake. Note: Discard the 2 rear work lights. Lower the attachment, shut off the engine, remove the key, and wait for all moving parts to stop.
- Page 3 Install the 8 screws (#10 x 1/2 inch) into the 2 adapter plates. g407252 Figure 4 1. Adapter plate 2. Screw (#10 x 1/2 inch) g407154 Figure 6 Install the 2 adapter plates to the front lighting 1. LED work light 2.