Operating A Cable Box Or Satellite Receiver (Sat) - Sony KP-48V80 Operating Instructions Manual

ME Operating a Cable Box or Satellite Receiver (SAT)
to operate a cable box or satellite receiver.
Bt RPO Ory
Manufacturer code numbers
(cable box)
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. 1. 201, 202, 203, 204, 205,
222, 206, 207, 208, 218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
Manufacturer code numbers
(satellite receiver)
Manufacturer Code number
Sony 801 (preset code for
remote control)
Geneal Electric 802, 808
Hitachi 805
Hughes 804
Panasonic 803
RCA/PROSCAN 802
Toshiba 806, 807
To operate the cable box or
satellite receiver (SAT)
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.
2 Press SAT/CABLE (FUNCTION).
For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
receiver.
—_
(vs)
If the remote control doesn't work
¢ Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
Tips &
¢ Ifmore than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
© Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
53