Toro 04012 Operator's Manual page 6

1. EZ-Turn switch
2. Open space for
operational lights
3. Parking break latch
4. Service brake
5. Operator presence control
3. Turn the power to the machine off
4. Pull the T-handle connector off the main battery power
supply connector affixed to the battery tray
1. T-handle connector
5. Clean and dry both the battery pack and charger connectors.
Figure 2
6. Handle
7. InfoCenter LCD display
8. Key switch
9. Speed control
(Figure 1).
(Figure
Figure 3
2. Main power supply
connector on the battery
platform
Important:
the strength of the connector plastic. Do not use
dielectric grease on the connector or battery contacts.
6. Align the positive connectors (marked with a "+") and push
together until they lock.
WARNING
Battery charging is dangerous when done improperly.
If there are workers present while a battery pack is
charging, designate a person to supervise the area
and ensure compliance with all safety instructions
contained in this manual. That person shall:
•
Be alert to people that come into the area and the
equipment they are using.
•
Stop any unsafe activities and prevent any unsafe
conditions.
•
Do not allow activity near the charger or battery
g017156
pack that might result in either being bumped or
knocked over.
•
Do not allow the operation of any equipment that
could produce a spark or flame or discharge water
or other liquids on or around the battery pack or
charger.
3).
g259735
6
Do not use strong solvents that degrade