Toro TX 1000 Installation Instructions

Ignition service kit compact tool carrier

Hide thumbs Also See for TX 1000:

Download this manual

Ignition Service Kit

TX 1000 Compact Tool Carrier

Model No. 137-9050

This product contains a chemical or chemicals known to the State of California

Note:

Determine the left and right sides of the machine from the normal operating position.

Safety

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area

of potential danger. Replace any decal that is damaged or missing.

1. Engine—stop

2. Engine—run

8111 Lyndale Avenue South

Bloomington, MN 55420

Proposition 65 Warning

to cause cancer, birth defects, or reproductive harm.

137-9052

3. Engine—start

WARNING

CALIFORNIA

decal137-9052

Form No. 3418-578 Rev A

Installation Instructions

Original Instructions (EN)

Printed in the USA

Page 1 Form No. 3418-578 Rev A Ignition Service Kit TX 1000 Compact Tool Carrier Model No. 137-9050 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Plate Ignition switch Decal Install the switch. Screw Wire-harness adapter Preparing the Machine No Parts Required Procedure Park the machine on a level surface.
Page 3 Installing the Switch Parts needed for this procedure: Plate Ignition switch Decal Screw g231591 Figure 3 Wire-harness adapter 1. Switch 2. Wire harness Align the plate with the edges on the frame Procedure (Figure Open the hood and secure the prop rod. Disconnect the battery;...
Page 4 g230873 Figure 5 1. Harness adapter 4. Decal 2. Switch 5. Nut 3. Plate Connect the wire harness to the adapter. Secure the assembly to the frame using the 2 self-tapping screws (Figure g230874 Figure 6 1. Screws Plug the main connector to the adapter on the key switch.

137-9050